IMPORTANT SAFETY INSTRUCTIONS
• To avoid injury or damage, mount only on a surface that is sturdy.
• To avoid electric shock, make sure the electricity is turned o
the main circuit breaker panel. If you are replacing an existing
xture, turn off the following in order: fixture, wall switch, and main
fi
fuse or breaker box.
Note: Some types of fuses must be unscrewed to shut the
power off.
• If you are unclear as to how to proceed, please consult a licensed
electrician.
UNPACK THE FIXTURE: Check the contents of the box. Box should contain all items on the parts
diagram.
ff at
INSTALLATION INSTRUCTIONS
1. Measure Canopy (D) height with measuring tape. Adjust Nipple (E) on Mounting Plate (A) to the
height of measured Canopy (D) plus 1/4" to allow them to protrude through Canopy (D) during
installation. Lock Nipple (E) in place with the hex nuts.
2. Secure Mounting Plate (A) to the junction box (not included) using Mounting Screws (B) provided.
Ensure Mounting Plate (A) is positioned with Nipple (E) pointing away from the junction box.
3. Place Canopy (D) against the ceiling by inserting Nipple (E) through the appropriate hole located
on Canopy (D). Adjust Nipple (E) and hex nuts until 1/4' of the threaded portion is visible. Remove
Canopy (D) from ceiling and set it aside.
Note: If 1/4" of Nipple (E) is not visible, remove Canopy (D) and re-adjust Nipple (E) to proper
length and lock it in place with the hex nuts.
4 Using the wire graph below, connect the appropriate wires from the fixture to the corresponding
wires in the electrical junction box (not included) and secure Wire Connectors (C).
A. Connect the ground wire (bare copper or green)
from your fixture to the:
1) ground wire in the junction box, or
2) ground screw in the junction box
B. Connect the BLACK house wire to fixture hot
wire that corresponds to diagram (black, round
& smooth, white/grey with tracer, brown/gold
without tracer).
C. Connect the WHITE house wire to fixture neutral
wire that corresponds to diagram (white,
ribbed/ridged, white/grey without tracer,
brown/gold with tracer).
5. Place all wires and Wire Connectors (C) back into the junction box.
6. Place Canopy (D) against the ceiling, ensuring Nipple (E) is protruding through the hole in Canopy
(D). Secure the fixture in place to the Mounting Plate (A) with Cap Nut (G).
Note: If fixture does not sit flush against the ceiling, remove fixture and readjust Nipple (E)
and hex nuts.
7. Install light bulbs (not included) into Sockets (K).
8. Position Shade (F) into Shade Holder (J).
9. Pull Springed Shade Holder (J) and lock Shade (F) in place.
Enjoy your new fixture!
HELPFUL TOOLS: Safety Goggles, Screwdriver, Wire Cutter/Stripper, Ladder, Measuring Tape
Loading...