Caution: You must read this before you proceed.
Dining Chair
1 OF 7
Label Picture Description QTY
A Chair Back 1PC
B Chair Seat 1PC
C Front Legs 2PCS
Label Picture Description QTY
a
b Flat Washer 9
c Spring Washer 9
d Allen Key 1
Dia. M8 Bolt: 60
9
mm(L)
2 OF 7
Before Beginning Assembly: Unpack all the parts for a clear overview.
Pack A for locking the back panel of
the seat to the horizontal panel of the
backrest:
Five Dia.M8 Bolts:60mm(a)+five Flat
Washers(b)+ five Spring Washers(c)
Pack B for Locking the Front Legs to
the front corner blocks of the
seat:Four Dia.M8 Bolts:60
mm(a)+four Flat Washers(b) +four
Spring Washers(c)
Allen Key
3 OF 7
Step 1
Chair Back
Place the Chair Back(A) on a clean, non-marring surface.
Take out the two Wooden Legs and the package of Hardware accessories.
Step 2
Chair Seat
Put the Chair Back(A) onto a clean and flat table or surface.
Align the positioning dowels on the Chair Seat(B) with the mounting position
located on the Chair Back(A).
Use your left hand to push the seat frame floorwards, depicted by Arrow 1.
This action helps to ensure the Chair Seat(B) is pressed towards to the
Chair Back(A) with no gap between these.
Then, lock the middle mounting position first and then the corner mounting
positions using Bolts(a), Spring Washers(c) and Flat Washers(b) with Allen
Key(d).
At this point of assembly, DO NOT overfasten the connections.
4 OF 7
Step 3
Next, place the chair onto the side of a table with the legs facing skywards.
Insert each front leg completely vertically into each seat frame corner.
PRESS FIRMLY DOWN with your hand until there is no gap.
Caution: Do not position the chair as shown in Picture 2, as it may
cause gaps.
Attach Front Legs using Bolt(a), Spring Washer(c) and Flat Washers(b) with
Allen Key(d).
Tighten the bottom Bolt first, then the top Bolt.
Caution: Tighten until secure and stable only, over tightening can cause
damage to the product.
Step 4
If wobble
Test again
30CM~50CM
5 OF 7
Place the chair on a LEVEL SURFACE to see if it wobbles.
If it wobbles, lift the chair 30cm to 50cm from the ground.
Keep your feet and toes well away from the drop zone.
Drop the chair freely and vertically with the four legs hitting the ground at the
same time.
This Drop Test will help to ensure that all the bolts and gaps reach full
alignment status.
Test again for evenness on a LEVEL SURFACE.
If no wobble is found, proceed to tighten all the bolts.
CAUTION : When tightening these bolts, tighten sequentially.
DO NOT tighten any bolt fully and then move to the next one, this could
cause the frame to warp.
If there is still wobbles, loosen the bolts and execute this same drop test.
Caution: Sitting on a wobbly chair can cause damage to the product.
Step 5
Finally, seal the Seat Base Cover back on to the underside of the chair seat.
Turn it the right side up.
Your Chair is ready for use.
6 OF 7
7 OF 7
Loading...