Canon 230 User Manual

We don't prepare the User Manual for the module because it is not sold to the end user directly.
Please refer to the Specification Sheet for more details about the module.
For the module installation to the host equipment please follow the interface specification (installation procedure).

FCC/IC Notice for model: ES200
Following statement must be included in the user manual of host device.
The end product must be labeled

“Contains FCC ID: AZD230” and “Contains IC: 498J‐230”

Model: DS126701 is the host device of ES200.

FCC/IC NOTICE
Model DS126701 (including WLAN Module Model ES200, FCC ID:AZD230/IC:498J-230)

This device complies with part 15 of FCC Rules and Industry Canada’s licence‐exempt RSSs.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.

Do not make any changes or modifications to the equipment unless otherwise specified in the manual. If such changes or modifications should be
made, you could be required to stop operation of the equipment.

This transmitter must not be co‐located or operated in conjunction with any other antenna or transmitter

except Canon accessories supplied or designated for this product.

The available scientific evidence does not show that any health problems are associated with using low power wireless devices. There is no proof,
however, that these low power wireless devices are absolutely safe. Low power Wireless devices emit low levels of radio frequency energy (RF) in the

microwave range while being used. Whereas high levels of RF can produce health effects (by heating tissue), exposure of low‐level RF that does not
produce heating effects causes no known adverse health effects. Many studies of low‐level RF exposures have not found any biological effects. Some

studies have suggested that some biological effects might occur, but such findings have not been confirmed by additional research. This model has
been tested and found to comply with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency

(RF) Exposure Guidelines and RSS‐102 of the IC radio frequency (RF) Exposure rules.