Candy CTS5142W User Manual

DOUBLE DOOR
EN
34351_41018720_EN.indd 134351_41018720_EN.indd 1 15.12.2006 6:40:3615.12.2006 6:40:36
2 EN
NB. This is the rating plate. If you need to contact our Service Department in the event of faults, remember to give them the information on the plate.
DOUBLE DOOR
CONTROL PANEL
The thermostat box to control the appliance is located inside the fridge compartment on the top right. To check whether the appliance is functioning, make sure that the thermostat knob is not set on „0“.
DEFROSTING and FREEZING
The rating plate states the maximum quantity of foods that can be frozen, (see figure 2). Freezing is guaranteed with any knob setting.
(Figure 2)
Defrosting of the fridge compartment occurs automatically in this product.
We recommend you defrost the freezer area when the layer of frost is more than 3 mm thick.
A small amount of frost or drops of water on the back of the fridge compartment when the fridge is working is normal
Make sure the water outlet is always clean. Make sure foods do not touch the back or sides of the fridge compartment
REVERSING THE OPENING OF THE DOORS
In order to reverse the opening of the doors, follow the indications in relation to the insert and hinge type your product is made up of.
Place or tilt the fridge at a 45° angle, since it is necessary to work on the bottom of the appliance
1
Remove the middle screw and remove the top door
3
Remove the bottom hinge by removing the screws, the plug and washers, then remove the bottom door
2
A
34351_41018720_EN.indd 234351_41018720_EN.indd 2 15.12.2006 6:40:3615.12.2006 6:40:36
3 EN
B
Remove the caps (A) and (B), loosen the screws and partially remove the panel.
Unscrew the right hinge
5
Mark and break the left-hand slot on the panel, in the insert area
Flip the top left-hand hinge found in the accessories kit
7
Remove the plug on the left-hand side and insert it on the right hand-side of the central and lower inserts.
8
Reassemble the hinges and doors working from bottom to top, 1 2 3
9
Place or tilt the fridge at a 45° angle, since it is necessary to work on the bottom of the appliance
1
Remove the bottom hinge by removing the screws, the plug and washers, then remove the bottom door.
2
Unscrew the central hinge and remove the top door
3
Unscrew the hinge from the fridge door and mount the one supplied on the other side
4
Invert the position of the closure plug of the insert
5
Remove the closure plug of the panel
6
Flip the top left-hand hinge found in the accessories kit
7
Insert the pin in the hinge.
8
Place the closure plug of the panel
9
Remove the plug on the left-hand side and insert it on the right hand-side of the central and lower inserts.
10
Reassemble the hinges and doors working from bottom to top. 1 2 3
11
To reverse the handles: Remove the outer caps from the right-hand side of the doors
12
Unscrew the handles from the left hand-side and move them to the right hand-side of the product. Position the outer caps on the left hand-side.
13
4
6
34351_41018720_EN.indd 334351_41018720_EN.indd 3 15.12.2006 6:40:3715.12.2006 6:40:37
Z STUDIO > 11-2006 – 41018720
34351_41018720_EN.indd 434351_41018720_EN.indd 4 15.12.2006 6:40:4015.12.2006 6:40:40
Loading...