INSTRUCTION BOOK
Instructions for installation and use
CANDY
Frost Free Fridge Freezer
CRCF5174W
The light design
English
INTRODUCTION
DEAR CUSTOMER
T
hank you for buying this fridge freezer. To ensure that you get the best results from your
new product please read and follow these instructions carefully and operate the machine accordingly.
This booklet provides important guidelines for safe use, installation, maintenance and some
useful advice for getting the best from your appliances.
Please ensure that the packing material is disposed of in accordance with the current environmental requirements.
When disposing of any refrigerator freezer equipment please contact your local waste disposal department for advice on safe disposal.
This appliance must be only used for its intended purpose.
3
CAUTION
The appliance is not intended for use by young children or infirm person without supervision.
Young children should be supervised to ensure that they don’t play with the appliance.
GENERAL
This product is widely used in homes for refrigeration and preserving foods, such as bever-
ages and fruit.. It’s mostly suitable for refrigerating and preserving foods such as fruits and
beverage. It enjoys the advantage of being smaller than larger models on the market, having
a lower energy consumption and is easy to use.
UNPACKING YOUR PRODUCT
WARNING: Use two or more people to move fridge freezer. Failure to do so can result
in back or other injury.
Remove tape and any labels from your refrigerator freezer before using (except the rating
label). To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or
glue residue can also be easily removed by rubbing a small amount of liquid soap over the
adhesive with your fingers. Wipe with warm water and dry. Do not use sharp instruments,
rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These products can damage the surface of your refrigerator-freezer. When moving the refrigeratorfreezer, do not tilt the refrigerator-freezer beyond 45°from upright position.
INTRODUCTION
CLEANING BEFORE USE
4
After you remove all of the packaging materials, especially the foam between the outside
condenser and cabinet clean the inside of your fridge freezer before using it.
ELECTRICAL REQUIREMENT
WARNING: DO NOT REMOVE GROUND PRONG.
DO NOT USE AN ADAPTOR.
DO NOT USE EXTENSION CORD.
Failure to follow these instructions can result in death, fire or electrical shock. Before you
move your refrigerator-freezer into its final location, it is important to make sure you have
the proper electrical connection.
RECOMENDED EARTHING METHOD
AC220-240Volt /50Hz ,AC only 10 ampere fused and properly earthed electrical supply is required. It is recommended that a separate circuit serving only this appliance be provided. Use
a receptacle which cannot be turned off with a switch or pull chain. Do not use an extension
cord.
NOTE: Before performing any type of installation, disconnect the fridge freezer from the
electrical source. When you are finished, connect the fridge freezer to the electrical source
and reset the control to the desired setting.
SAFETY PRECAUTIONS
Please always follow the safety advice listed below:
The unit should be operated in the absence of flammable or explosive fumes.
It is prohibited to put the flammable, acid or volatile
goods in cabinet.
Please unplug the unit immediately if you find any
abnormal smell or smoke, and contact your local service center.
Please don’t allow water on the cabinet, or put a vessel full of water on the refrigerator. If the refrigerator is
wet, the electrical insulation capability may be weakened.
5
Hanging or sitting on the door is very dangerous, it
may overturn the unit and subvert the goods in (or
on) the refrigerator.
INSTALLATION
6
The unit should be placed in a ventilated and dry environment.
Do not put the unit in direct sunshine, and keep it as far as
possible from heat sources.
If the product is not levelled during the installation the doors
may not close or seal properly, causing cooling, frost or
moisture problems. It’s very important that you may either
turn the adjustable feet clockwise to raise the side to the
product or turn counter-clockwise to lower the side.
Don’t put the unit in cold area.
There should be enough spare space around the unit as
shown, to allow proper ventilation.