INSTRUCTION MANUAL
P/N : 38801K514
PRINTED IN KOREA
SUPREME IMAGE
Video Surveilance Camera
High Resolution Indoor IR Dome Camera
CS-PD710IR
CS-PD720IR
CS-PD8950
Design and specifications are subject to change without notice.Design and specifications are subject to change without notice.
CONTENTS
02
03
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION :
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within an equilateral
triangle is intended to alert the user to the presence of uninsulated
"dangerous voltage" within the product's enclosure that may be of
sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to
alert the user to the presence of important operating and maintenance
(servicing) instructions in the literature accompanying the appliance.
INFORMATION FOR USER
Regulatory Notice
CAUTION
CAU TIO N
: To prevent electric shock and risk of fire hazards:
Do NOT use other than specified power source.
Do NOT expose this appliance to rain or moisture.
1. Information for user
2. Contents
3. Precautions
4. Features
5. Part names
6. Installation
7. Accessories and others
8. Connection
9. Dimensions
10. Setup Menu
CS-PD710IR
CS-PD720IR
CS-PD8950
11. Specifications
CS-PD710IR
CS-PD720IR
CS-PD8950
12. Troubleshooting
2p
3p
4p
5p
6p
7p
8P
9P
12P
13p
25p
37p
52p
46p
48p
50p
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions :
(1)This device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and use in accordance with the instructions, may cause harmful interference
to radio communications.
Operation of this equipment in a residential area is likely to cause interference, in which
case the user will be required to correct the interference at his own expense.
WARNING
WARNING
- Changes or modifications not expressly approved by the
manufacturer could void the user's authority to operate the equipment.
04
05
Precautions
Do use the camera under conditions where temperatures are within -10°C to 50°C.
Especially be careful for ventilation under high temperature.
Do not install the camera in extreme temperature conditions.
Do not install or use the camera in an environment where the
humidity is high.
Do not install the camera under unstable lighting conditions.
It can cause the image quality to be poor.
Severe lighting change or flicker can cause the camera to work improperly.
Never use the camera close to a gas or oil leak.
Do not disassemble the camera.
It can cause malfunctions to occur.
There are no user-serviceable parts inside it.
Do not drop the camera or subject them to physical shocks.
It can cause malfunctions to occur.
Never keep the camera face to strong light directiy.
It can damage CCD.
Do not exposed the camera to rain or spill beverage on it.
Note
it gets wet, wipe it dry immediately. Liquids can contain minerals that corrode
the electronic components.
If the camera is exposed to spotlight or object reflecting the strong light,
smear or blooming may occur.
Please check the power whether it satisfies the normal specification before
connecting the camera.
Features
COLOR IR DOME CAMERA
This color video camera is designed for use in monitoring systems.
- True WDR with model CS-PD720IR
- 2D + 3D Digital Noise Reduction
- Digital Slow Shutter
- High Light Compensation
- Privacy Mask Function
- 2 CDS 27pcs IR LED System : IR Distance : 20m
- ICR Day & Night
- Easy operation by On Screen Display
- Safety strap holds dome cover in place while making adjustments
CS-PD710IR
CS-PD720IR CS-PD8950
Resolution
Lens
700 TV Lines
2.2 mega-pixel
2.8~12mm
2.8~11mm 2.8~10mm
WDR Digital WDR True WDR WDR
Special function Defog Digital Image
Stabilizer
Defog, Dead pixel
Compensation
Part Names
06
07
PLASTIC HOUSING
IR Type
Plastic Dome Camera
The camera can be installed on a junction box or directiy on the
wall/ceiling.
1. Attach the surface mount bracket to the ceiling using the (4)
mount screws.
2. Draw out and position the power/video wires for connection
3. Connect the dome base to the surface mount bracket using
the screws with rubber rings.
4. Adjust the image by using the focus and zoom lever.
5. Place the dome cover over the base and adjust the cover shield
6. Secure the dome cover to the base using the L-wrench.
Installation
Lock Screw
Focus / Zoom Lever
OSD Board
IR
AC24V
Power Board
Dome Base
Decoration Ring
L-Wrench
Dome cover
09
Accessories and others
Dome Accessories
Mount Screw
User's ManualL-Wrench
Brackets Optional
Wall mount Bracket
Connection
DC 12V power Input Model
- Connect the video out jack to the video in jack monitor.
- Connect the adapter to the power input connector.
- Use a DC12V and 1A adaptor.
Video
(Yellow)
Power
(Red)
Video Output
GND
No.
YellowVideo Out
Function Terminal Color
#1
Power Input Red
#2
08
Connection
11
10
IMPORTANT REMINDER:
- Power supply
1) To avoid fire or shock hazard, must use a UL listed power
supply.
- Monitor Impedance
1) Set the impedance switch to a 75Ω standard position.
2) When the monitor is set to high impedance mode, the
picture may become blurred. In this case, check the position
of monitor impedance switch.
- DOME/WINDOW CARE
1) Handle the dome carefully to prevent scratching.
If a scratch appears over the lens you can turn the dome
to move the scratch out of view.
* Please keep dome cover and camera lens clean for better picture.
* To avoid smearing, do not directly expose the camera lens to strong
light source such as the sun or spot lights.
Caution!
AC 24V / DC 12V Power Input Model (Optional)
- The wire is non-polarized
- Use AC24V power source or DC 12V power source
- Use AC24V 1A adaptor or DC12V 1A Adaptor.
Balun
(Black)
No.
YellowVideo Out
Balun Black
Function Terminal Color
#1
Power Input
Green
#2
#3
Video
(Yellow)
Power
(Green)
Video Output
GND
Video
(Yellow)
Power
(Green)
13
Setup Menu “CS-PD710IR”
Dimensions
12
PLASTIC DOME HOUSING
53.0 44.5
38.7
83.5
46.0
( Unit: mm )
MAIN MENU
The menu consists of the “Main Menu” and “Sub Menu”.
The main menu is 8 kinds of camera functions can be selected.
To the right of each main menu selection, the sub-menu is
displayed.
If you want save the menu, select [SAVE].
If you want not save the menu, select [RESTORE]
If you want factory default the menu, select [INITIAL]
MENU
EXPOSUREDC
DAY/NIGHT
WHITE BAL.
MONITOR
IMAGE
DNR
MOTION
SYSTEM
EXIT
ALC
EXTERN
ATW
MIDDLE
OFF
SAVE
※Note※
In Day/Night Menu, "EXTERN" is displayed for IR model
and “AUTO” is displyed for without IR model.
15
Setup Menu “CS-PD710IR”
Setup Menu “CS-PD710IR”
14
EXPOSURE
◈ EXPOSURE : You can select exposure mode
▷ LENS : You can select lens type
▶ ALC / ELC
▷ BRIGHTNESS : You can adjust brightness level.
▶ 0 (dark) ~ 20 (bright) steps
▷ SHUTTER : You can set to auto or manual mode.
▶ AUTO, 1/60(50), FlK, 1/250, 1/500, 1/700, 1/1000, 1/1600,
1/2500, 1/5000, 1/7000, 1/10000, 1/30000, 1/60000,
1/120000sec
* If the lens is ALC, shutter is 1/60,1/50.
▷ FLICKERLESS : Select Flickerless mode
▶ OFF / ON (remove screen flicker)
▷ AGC : You can select auto gain control level.
▶ 0 ~ 20 steps
▷ SENSOR UP : You can select sensor up(Digital Slow Shutter)
level.
▶ LEVEL : OFF, x2~x512 steps
▷ IRIS OFFSET : You can select iris offset level .
▶ 0 ~ 20 steps
EXPOSURE
LENS
BRIGHTNESS
SHUTTER
FLK
AGC
SENSOR UP
IRIS OFFSET
ENTER - RETURN
ALC
10
1/60
OFF
19
OFF
10
EXPOSURE
LENS
BRIGHTNESS
SHUTTER
FLK
AGC
SENSOR UP
IRIS OFFSET
ENTER - RETURN
ELC
10
AUTO
OFF
19
OFF
NOT USED
MENU
EXPOSUREDC
DAY/NIGHT
WHITE BAL.
MONITOR
IMAGE
DNR
MOTION
SYSTEM
EXIT
ALC
EXTERN
ATW
MIDDLE
OFF
SAVE
DAY & NIGHT
◈ DAY&NIGHT : You can select
day&night mode
▷ DAY : Day&Night only color mode
▷ AUTO : Day&Night auto mode
▷ NIGHT: Day&Night only night mode
▷ EXTERN : Day&Night EXT mode
▷ CDS : Day&Night IR LED mode
▶ AGC THRS : 0 ~ 20 steps
▶ AGC MARGIN : 0 ~ 20 steps
▶ D/N DELAY : 0 ~ 15 sec
▶ B/W BURST : OFF / ON
▶ EXTERN S/W : LOW / HIGH
▶ CDS D→N : 0 ~ 20 steps
▶ CDS N→D : 0 ~ 20 steps
▶ SMART IR : OFF / ON
► LED POWER : OFF / DIMMING /
FULL
► ANTI-SAT : 0 ~ 20 steps
► SAT. ATEA : 0 ~ 20 steps
DAY/NIGHT
MODE
AGC THRS
AGC MARGIN
D/N DELAY
B/W BURST
SMART IR
RETURN
AUTO
10
10
2 SEC
OFF
DAY/NIGHT
MODE
B/W BURST
SMART IR
RETURN
NIGHT
OFF
DAY/NIGHT
MODE
EXTERN S/W
D/N DELAY
B/W BURST
SMART IR
RETURN
EXTERN
LOW
2 SEC
OFF
DAY/NIGHT
MODE
CDS D N
CDS N D
D/N DELAY
B/W BURST
SMART IR
RETURN
CDS
10
10
2 SEC
OFF
MENU
EXPOSUREDC
DAY/NIGHT
WHITE BAL.
MONITOR
IMAGE
DNR
MOTION
SYSTEM
EXIT
ALC
EXTERN
ATW
MIDDLE
OFF
SAVE
17
Setup Menu “CS-PD710IR”
Setup Menu “CS-PD710IR”
16
WHITE BALANCE
◈ WHITE BAL : You can select white balance mode.
▷ ATW / PUSH→SET / MANUAL(RED / BLUE)
▶ ATW : Automatically adjusts color according to
the available lighting.(2500°K → 9500°K)
▶ PUSH→SET : It is a fixed white balance mode that may
be automatically readjusted only by pressing SET Button
in ONE PUSH mode.
▶ MANUAL : Color can be corrected when the user
increases or decreases ”Red Gain" or "Blue Gain".
► RED GAIN : Adjust R gain value 0 ~ 20 steps
► BLUE GAIN : Adjust B gain value 0 ~ 20 steps
W.B. MANUAL
RED
BLUE
ENTER - RETURN
9
15
MENU
EXPOSUREDC
DAY/NIGHT
WHITE BAL.
MONITOR
IMAGE
DNR
MOTION
SYSTEM
EXIT
ALC
EXTERN
ATW
MIDDLE
OFF
SAVE
MONITOR
◈ MONITOR : You can adjust camera image.
▷ GAMMA : You can adjust gamma on screen
▶ LEVEL : 0.35 / 0.40 / 0.45 / 0.50 / 0.55 / 0.60 / 0.65
/ 0.70 steps
▷ CHROMA: You can adjust chroma on screen
▶ LEVEL : 0 ~ 20 steps
▷ SHARPNESS : You can adjust sharpness on screen
▶ LEVEL : 0 ~ 20 steps
▷ SHADING : You can adjust lens shading on screen.
▶ LEVEL : 0 ~ 20 steps
▷ PED. LV. : You can adjust PED level on screen.
▶ LEVEL : 0 ~ 20 steps
MONITOR
GAMMA
CHROMA
SHARPNESS
SHADING
PED. LV.
ENTER - RETURN
0.45
13
10
0
8
MENU
EXPOSUREDC
DAY/NIGHT
WHITE BAL.
MONITOR
IMAGE
DNR
MOTION
SYSTEM
EXIT
ALC
EXTERN
ATW
MIDDLE
OFF
SAVE
Loading...