Campomatic RC1808 Turbo Instruction Manual

RC1808

TURBO

1800W MAX (1600W) IEC

Made In China

INSTRUCTION MANUAL

Caution: Read and follow all safety and operating instruction before first use of this product.

Campomatic S.R.L. Via Configliachi 5/B . 35031, Abano Terme (Padova), ITALIA

www.campomatic.com

RC1808 Turbo

2

IMPORTANT SAFETY INSTRUCTION

WARNING:

Your safety is important to us. To reduce the risk of fire, electrical shock,
injury to person or damage when using your vacuum cleaner, follow basic
safety precautions including the following:

1- Read this manual before assembling or using your vacuum cleaner.
2- To reduce the risk of electric shock – Do not use outdoors or on wet

surfaces.

3- Disconnect electrical supply before servicing or cleaning out brush

area. Failure to do so could result in electrical shock.

4- Do not unplug by pulling on cord. To unplug, grasp the plug, not the

cord.

5- Hold plug when rewinding onto cord reel.-Do not allow plug to whip

when rewinding.

6- Do not use with damaged cord or plug. If cleaner is not working as it

should, has been dropped, damaged, left outdoors, or dropped into
water. Return it to a sears service center /department.

7- Do not pull or carry by cord, use cord as a handle, close door on cord,

or pull cord around sharp edges or corners. Do not run cleaner over
cord. Keep cord away from heated surfaces.

8- Do not leave cleaner when plugged in. Unplug from outlet when not

in use and before servicing.

9- Do not allow to be used as a toy. Close attention is necessary when

used by or near children.
10- Do not handle plug or cleaner with wet hands.
11- Do not put any objects into openings.
12- Do not use with any opening blocked, Keep free of dust, lint, hair, and

anything that may reduce airflow.

EN

RC1808 Turbo

3

13- Keep hair, loose clothing, fingers, and all parts of body away from

openings and moving parts.
14- Do not use cleaner without dust bag and /or filters in place.
15- Always change the dust bag after vacuuming carpet cleaners or

freshener, powders and fine dust. These products clog the bag,

reduce airflow and can cause the bag to burst. Failure to change bag

could cause permanent damage to the cleaner.
16- Do not use cleaner to pick up sharp hard objects, small toys, pins,

paper clips, etc. they may damage the cleaner or dust bag.
17- Do not use cleaner to pick up anything that is burning or smoking,

such as hot ashes, cigarette, matches.
18- Do not use cleaner to pick up flammable or combustible liquids

(cleaning fluid, gasoline, perfumes, etc.) or use in areas where they

may be present. The fumes from these substances can create a fire

hazard or explosion.
19- Use extra care when cleaning on stairs. Do not put on chairs, table,

etc. keep on floor.
20- This appliance is not intended for use by persons (including children)

with reduced physical, sensory or mental capabilities, or lack of

experience and knowledge, unless they have been given supervision

or instruction concerning use of the appliance by a person

responsible for their safety. Children should be supervised to ensure

that they do not play with the appliance

EN

RC1808 Turbo

4

PARTS AND FEATURES

EN

RC1808 Turbo

5

1. Switch pedal

2. Rear cover

3. Power adjust button

4. Air outlet grid

5. Cord rewind pedal

6. Rear wheel

7. Base

8. Air outlet button

9. Front cover

ASSEMBLY INSTRUCTION

1- Check the dust bag

Check if the dust bag is in place

10. Hand cover

11. Front cover lock

12. Indicator spring

13. Indicator cover

14. Indicator body

15. Indicator

16. Filter

17. Dust bag

18. Bag holder

2- Connect the hose to the cleaner

Insert the hose assembly to the hole in the base and rotate the
suction until it is locked into the right place.

RC1808 Turbo

6

3- Connect the hose to the telescopic tube

Attach the telescopic tube to the hose by pushing and twisting

together (Twist and pull apart to dismantle.)

.

4- Connect the telescopic tube to the floor brush

Attach the telescopic tube to the floor brush by pushing and twisting
together (Twist and pull apart to dismantle.)

5- Extend and rewind the power cord

5a- Extend the power cord and connect it to the socketࠋ

Caution: do not extend the power cord to the yellow mark.

EN