Campomatic JS700 User Manual

Download

JS700

ProJuicer 700W

INSTRUCTION MANUAL

Made in China

WWW.CAMPOMATIC.COM

JS700

Important Safeguards

1. This appliance is intended for household use only.

2. Read all instructions before use, and see all diagrams, and keep these

instructions for further reference.

3. Don't operate the appliance for more than 40 seconds at a time when juicing heavy loads and let it cool down sufficiently afterwards.

4. Check if the voltage indicated on the base of the appliance corresponds to the local mains voltage before you connect the appliance.

5. Don't let cord hang over edge of table or counter, do not let cord contact hot surface, incuding the stove.

6. Never use accessories or parts mad

recommended or sold; may cause a risk of injury to persons.

7. Do not use the appliance if it’s power cord, plug, blade device or other . In the event of any damage to the power cord or blade

part is damaged device of this product, it can only be replaced with a special one for use with this product or Midea special servicing agency.

8. Only use the appliance when handle is locked, never reach into the feeding tube with your fingers of an object while the appliance is running.

9. Don't remove the pulp container when the appliance is in operation.

10. Make sure all parts are corr

appliance.

11. The appliance is not intended for use by young children or infirm persons without supervision.

ectly mounted before you switch on the

e by other manufactures not

12. Make sure the motor and blade have completely stopped before dis assembling and cleaning.

13. Avoid touching the sharp blades, especially when the appliance is plugged in.

14. Don't immerse the motor base, plug or cord in water or any other liquid.

P leas e f o l l o w t he a bov e s a f e ty p r e ca u tions

Technical Data

JS700

Product name

Juicer

JS700

230-240 ~V

General Description

50Hz

PowerFrequencyVoltageModel

700-760W

Capacity

1250ml

A、 Pusher B、 Lid D、 Juice collector

G、 Clutch J、 Foam separator M、 Pulp container

E、 Spout H、 Motor base

K、 Jug lid L、 Juice jug N、 Power cord

C、 Filter F、 Handle

I、 Control knob

Using your Product

P repa r ing f o r u s e:

1.Wash all detachable parts (see chapter cleaning)

2.Set the control knob to position 0 to switch the appliance off.

U s i n g t h e j u i c er:

JS700

1. Pull the power cord out of the cord storage

compartment at the back of the appliance.

2. Place the juice collector into the appliance.

3. Put the filter in the juice collector, make sure

the filter is fitted securely onto the clutch("click") Always check the filter before use, if you detect

any cracks or damage do not use the appliance and contact the nearest appliance center or take the appliance to your dealer.

4. Place the pu by tilting it forwards slightly. Insert the top and

lp container into the appliance

first and then push home the bottom end. While you are preparing juice, you can empty

the pulp container by switching the appliance off and carefully removing the pulp container. Reassemble the empty pulp container before you continue juicing.

5. Hold the lid over the filter and lower it into

position , snap the handle onto the lid to lock it into place ("click"). Make sure the handle is locked into position on either side of the lid.

JS700

8. To separate the foam from the juice when pouring the juice into a

glass, insert the foam separator by sliding it into the juice jug .

Attention: If you want your drink to have a foamy layer, do not use the foam seperator!

9. The appliance will only function if all parts have been properly assembled and the lid has been properly locked in place with the handle .

---Wash the fruit /vegetables well and cut them into picecs that fit into the feeding tube without forcing.

---Make sure the juice jug has been placed under spout.

6. Slide the pusher into the feeding tube by aligning the groove in the pusher with the small protrusion on the inside of the feeding tube.

7. Place the juice jug under the spout. Place the lid on the juice jug to avoid splattering or if you want to store the juice in the refrigerator.

10. Plug cord plug into the p turning the control knob to setting "Ⅰ" (lower speed) or "Ⅱ"(normal speed).

---Speed Ⅰ is especially suitable for soft fruits and vegetables. Such as watermelons、 grapes、 tomatoes、 cucumbers and raspberries.

---Speed Ⅱis suitable for all kinds of fruits and vegetables.

ower socket, switch the appliance on by

11. Put the pre-cut pieces in the feeding tube .

12. Gently press them down towards the rotating

filter by means of the pusher. N o tic e : do not exert too much pressure on the pusher, as this could affect the quality of the end result and it could even cause the filter to come to a halt, never insert your fingers or an object into feeding.

JS700

13. After you have processed all ingredients and

the juice flow has stopped, switch the appliance off and wait till the filter has stopped rotating.

14. If the motor base starts to vibrate violently and produce less juice, switch it off, then remove and clean the filter.

T IP F O R U S E :

1. Use only good quality, fruit and vegetables, preferably fresh vegetables and ripe fruits, as they contain more juice.

2. Pineapples, beetroots, celery stalks, cucumbers, carrots, spinach, melons, tomatoes, pomegranates, oranges and grapes are particularly suitable for processing in the juicer extractor.

3. To extract the maximum amount of juice, always press the pusher down slowly.

4. The juicer is not suitable for processing very hard and/or fibrous/starchy fruits or vegetables such as sugar cane.

5. Apple juice may turn brown qui

down the process.

6. Fruits that contain starch, such as bananas, papayer, avocados, figs and mangoes are not suitable for processing in the juice extractor, use a food processor, blender or bar blender to process these fruits.

7. Drink the juice immediately after you have extracted it, if it is exposed to air for some time, the juice will lose its taste and nutritional value.

ckly. A few drop of lemon juice will slow

JS700

Cleaning and Caring

The appliance is easier to clean if you do so immediately after use.

1. Switch the appliance off, remove the plug from the wall socket and wait until the filter has stopped rotating.

2. Remove the dirty parts from the motor unit.

---Remove the pusher.

---open the handle.

---Remove the lid.

---Remove the pulp container.

---Remove the juice collector together with the

3. Clean these parts with the cleaning brush in warm water with some

washing-up liquid and rinse them under the tap.

4. Clean the motor base with a damp cloth, never immerse the motor base in water nor rinse it under the tap caring.

5. Avoid touching the sharp blades, especially when the appliance is plugged in.

C ar in g :

1. Please store the appliance on dry entironment.

2. Never put the filter, or any other parts, in a microwave oven.

3. Never store foods or drinks in the jug.

Troubleshooting

1. If, during use, the product is subjected to such abnormality as noise, smell, smog and increased temperature, disconnect the power supply

and stop the use.

2. In case the appliance fails to work, please check whether the power supply is properly connected, whether the switch is rotated to the on position and whether the fittings are in place.

3. If the appliance can not still function well after the above inspections, consult the designated servicing agency.

JS700

Special Announcement