Campbell Hausfeld FP2032, FP2030, FP2031, FP2033 User Manual

Do not operate

unit if damaged during shipping, handling or use. Damage may result in bursting and cause injury or property damage.

Since the air compressor and other

6. Do not stand on or use the pump or unit as a handhold.

7. Before each use, inspect compressed air system and electrical components for signs of damage, deterioration, weakness or leakage. Repair or replace defective items before using.

8. Check all fasteners at frequent intervals for proper tightness.

components (material pump, spray guns, filters, lubricators, hoses, etc.) used, make up a high pressure pumping system, the following safety precautions must be observed at all times:

1. Read all manuals included with this product carefully. Be thoroughly familiar with the controls and the proper use of the equipment.

2. Follow all local electrical and safety codes as well as in the US, National Electrical Codes (NEC) and Occupational Safety and Health Act (OSHA).

3. Only persons well acquainted with these rules of safe operation should be allowed to use the compressor.

4. Keep visitors away and NEVER allow children in the work area.

5. Wear safety glasses and use hearing protection when operating the pump or unit.

Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Retain instructions for future reference.

Portable oilless air compressors are for home and workshop use. All models are equipped with regulators, needle and ball bearings, and motors with automatic overload protection.

Safety Guidelines

This manual contains information that is very important to know and understand. This information is provided for SAFETY and to PREVENT EQUIPMENT PROBLEMS. To help recognize this information, observe the following symbols.

Danger indicates

an imminently hazardous situation which, if not avoided, will result in death or serious injury.

Warning indicates

a potentially hazardous situation which, if not avoided, could result in death or serious injury.

Caution indicates a

potentially hazardous situation which, if not avoided, may result in minor or moderate injury.

Notice indicates

important information, that if not followed, may cause damage to equipment.

Unpacking

After unpacking the unit, inspect carefully for any damage that may have occurred during transit. Make sure any loose fittings, bolts, etc., are tightened before putting unit into service. Have the serial number, model number, and parts list (with missing parts circled) before calling for assistance.

DO NOT RETURN THE PRODUCT TO THE RETAILER!

Operating Instructions

IN604200AV 1/02

Breathable Air Warning

This compressor/pump is not equipped and should not be used “as is” to supply breathing quality air. For any application of air for human consumption, the air compressor/pump will need to be fitted with suitable in-line safety and alarm equipment. This additional equipment is necessary to properly filter and purify the air to meet minimal specifications for Grade D breathing as described in Compressed Gas Association Commodity Specification G 7.1 1966, OSHA 29 CFR 1910. 134, and/or Canadian Standards Associations (CSA).

DISCLAIMER OF WARRANTIES In the event the compressor is used for the purpose of breathing air application and proper in-line safety and alarm equipment is not simultaneously used, existing warranties shall be voided, and Campbell Hausfeld disclaims any liability whatsoever for any loss, personal injury or damage.

Portable Handheld Air Compressor

Record the Model No., Serial No. and date of purchase located on the base below the pump in the space below.

Model No. ____________________

Serial No. ____________________

Date of purchase _________________

Retain these numbers for future reference.

Description

General Safety

Model FP2030, FP2031, FP2032, FP2033

For parts, product & service information

visit www.chpower.com

DANGER

WARNING

CAUTION

NOTICE

STOP!

WARNING

MANUAL

DANGER

Need

Assistance?

Call Us First!

1-800-543-8622

Do not locate the

compressor air inlet near steam, paint spray, sandblast areas or any other source of contamination. This debris will damage the motor.

This product is for

use on a nominal 120 volt circuit. Make sure that product is connected to an outlet having same configuration as plug.

WIRING

1. Local electrical wiring codes differ

from area to area. Source wiring, plug and protector must be rated for at least the amperage and voltage indicated on motor nameplate, and meet all electrical codes for this minimum.

2. Use a slow blow fuse type T or a circuit

breaker.

Overheating, short

circuiting and fire damage will result from inadequate wiring, etc.

NOTE: This compressor can be operated on a 115 volt, 15 amp circuit under the following conditions:

a. Circuit is not heavily loaded. b. Voltage supply is normal. c. Extension cords are of the minimum

gauge specified in this instruction manual.

d. Circuit is equipped with a 15 amp

circuit breaker or a 15 amp slow blow fuse type T.

EXTENSION CORDS

To avoid loss of

power and possible overheating, use additional air hose instead of extension cords to reach work area.

1. Use only a 3-wire extension cord that

has a 3-blade grounding plug, and a 3-slot receptacle that will accept plug on product.

2. Make sure extension cord is in good

condition, and heavy enough to carry current product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating.

Portable Handheld Air Compressor

Motors, electrical equipment and controls can cause electrical arcs that will ignite a flammable gas or vapor. Never operate or repair in or near a flammable gas or vapor. Never store flammable liquids or gases in the vicinity of the compressor.

Compressor parts may be hot even if the unit is stopped.

9. Keep fingers away from a running compressor; fast moving and hot parts will cause injury and/or burns.

10. If the equipment should start to abnormally vibrate, switch unit OFF (O) and check immediately for the cause. Vibration is generally a warning of trouble.

11. To reduce fire hazard, keep motor free of oil, solvent, or excessive grease.

12. Fast moving air will stir up dust and debris which may be harmful. Release air slowly when draining moisture or depressurizing the compressor system.

Any misuse of unit could cause property or equipment damage and/or personal injury.

Do not leave the compressor

unattended while the unit is running.

Never exceed the recommended pressure for any inflatable object. Do not over inflate objects. Over inflation could cause property damage and/or personal injury.

Always put the car

in park; set the emergency brake; and block the wheels (to stop them from moving) before using the compressor or property damage and/or personal injury could occur.

Always use a sep-

arate pressure gauge to check the actual pressure in tires and in low pressure inflatable objects.

SPRAYING PRECAUTIONS

Do not spray flammable materials in vicinity of open flame or near ignition sources including the compressor unit.

13. Do not smoke when spraying paint,

insecticides, or other flammable substances.

14. Use a face mask/

respirator when spraying and spray in a well ventilated area to prevent health and fire hazards.

15. Do not direct paint or other sprayed

material at the compressor. Locate compressor as far away from the spraying area as possible to minimize overspray accumulation on the compressor.

16. When spraying or cleaning with

solvents or toxic chemicals, follow the instructions provided by the chemical manufacturer.

It is extremely important to use the compressor in a clean, well ventilated area where the surrounding air temperature will not be more than 100°F.

General Safety (Cont.)

Figure 1

Electrical Data

Location

www.chpower.com

Pressure Regulator

Pressure Gauge

Air Outlet

On/Off Switch

Handle

CAUTION

WARNING

CAUTION

WARNING

CAUTION

NOTICE

+ 3 hidden pages