Page 1
Revised October 17th, 2018
Pump Kit Parts List
PK300 pump (1)
Wedges (4)
Hose clamp (1)
* Tubing has been preassembled
GFRCFT-1106 Large Sphere Fountain
(2 pieces)
Tools you will need
Level
This fountain takes cover
FTNCOV-MD
Base
31.5”L x 31.5”W x 9”H
112 lbs
Water Feature
32”W x 33.5”H
93 lbs
This fountain is compatible with a
#10 or #7 Refill Device
Fountain holds
approximately 10
gallons of water
COMPONENTS AND PARTS LIST
Page 2
Revised October 17th, 2018
GFRCFT-1106 Large Sphere Fountain
(2 pieces)
ASSEMBLY INSTRUCTIONS
1. Make sure you are assembling your fountain on a level surface.
2. Unpack the provided pump.
a. NOTE: Be sure to use the appropriate size adapter provided with the pump.
3. Place the pump in the center of the basin.
a. Note – Keep 18” of the pump cord in the basin with the pump for easier installation.
The remainder of the cord will drape over the back center of the basin.
4. Place the base over the basin with the access door at the back of the fountain. The basin
should touch the inside wall of the base, which will allow enough space to access to the
pump.
5. Run the pump cord through the channel that is cut into the bottom of the base.
6. Protect the top of the base with a towel, piece of cardboard, or something similar that will
not scratch the surface of the base.
7. Rest the sphere on the base.
8. Hook the pump to the tubing that comes attached to the sphere.
a. Note - If necessary, use the hose clamp to secure the tubing to the pump.
9. Set the sphere into place on the base.
a. Note – Do not allow pump to run dry, as it will cause damage to the pump.
WINTER CARE AND GENERAL FOUNTAIN INSTRUCTIONS
-W I N T E R C A R E -
Fountain bowls/tops and other fountain components, which collect water, should not be left outside in the winter since
any component, which fills with water and freezes may crack. Likewise components such as pedestals, which remain
in a basin, filled with water, which then freezes, may also crack or crumble. Ideally, therefore, a fountain should always
be stored indoors or in a dry protected place such as a covered porch away from the elements. However, if a fountain
must be left outside:
(1) Remove pump, rubber stoppers, drainpipes, finials, and other small components for storage indoors. Note
that stoppers or drainpipes are removed to allow drainage in the event water accumulates in any basin.
(2) Raise fountain base from ground with wood strips so that base will not freeze to the ground surface.
(3) Cover or wrap the fountain with burlap or other absorbent material (old blanket or towel) and then cover
securely with plastic, making sure that water will not accumulate in the basin or other fountain component and
freeze.
(4) Check fountain periodically to insure that plastic is secure and water is not accumulating in any fountain
component.
-G E N E R A L F O U N T A I N T I P S -
Install fountains on a level surface. You will need a properly grounded 110-volt (AC only) GFCI protected
receptacle near the fountain for your pump. All pumps are submersible and must be completely underwater to function
properly. Test all pumps and adjust to full output prior to assembly. It is not recommended that fountains be placed
directly on grass or dirt. Position the channel opening at the base of each fountain toward the electrical outlet to be
used since the pump cord will be threaded through this opening.
For more Campania product information visit www.campaniainternational.com
Loading...