PACKAGE CONTENTS
1
CM-TXLFB
1
Metal spring clip for belt or sun visor mounting
1
12” (30cm) Velcro Strap for mounting on
a wheelchair arm rest
2
#6 pan head screws to fasten to a counter or
a desk
Section 1
General Description
Camden Lazerpoint™ TXLFB Base is designed for use with the
following Key Fob transmitters:
CM-TXLF-1, CM-TXLF-2, & CM-TXLF-4.
Section 2
Installation
Insert a 1, 2 or 4 button transmitter into the base, button
side up until you hear a click and the FOB is secure. Removal
of the transmitter is accomplished by simply pushing a
pen or small screw driver through the oval slot on the back of
the base until the transmitter pops out.
Lazerpoint™ CM-TXLFB Series
FOB Base Station
Installation Instructions
FOB
To
Install
BASE
To
Remove
BASE
Visor Mounting
Turn the base over and slide the metal spring clip into the slot
located in the end until it stops. You should hear a click as it
locks into place. To remove the metal clip, gently insert a pen
or small screwdriver into the hole in the clip and depress lock.
Now completely slide the clip out from base.
Velcro Mounting
Turn the base over and insert the tapered end of the Velcro
strap into the slot on one side of the base. Pull through until
the base is mid-point along the Velcro strap. Place on the arm
of a chair and securely fasten both Velcro ends to each other.
Screw Mounting
Use the full size template on page 2 and mark both screw
locations. Drill two 1/8” pilot holes, 3/8” deep. Screw the
included #6 wood screws in, until they are approximately
1/8” above surface. Now slide base onto screws. The base
should be snug. If it is too tight to slide on, or too loose, simply
adjust both screws to suit.
To
Remove
BELT CLIP
BASE
To Install
VELCRO STRAP
See over for full size template
Page 1 of 2
Section 3
Warranty
Camden Door Controls guarantees the CM TXLFB mounting
base to be free from manufacturing defects for 3 years
from date of sale. If during the rst 3 years this product
fails to perform correctly, it may be returned to our factory
where it will be repaired or replaced (at our discretion)
without charge. Except as stated herein, Camden extends
no warranties expressed or implied regarding function,
performance or service.
Questions?
Call us toll-free at 1-877-226-3369
Lazerpoint™ CM-TXLFB Series Installation Instructions
1
1
8
"
[28mm]
"
15
[23mm]
16
CM-TXLFB
Full Size
Mounting Template for
CM-TXLFB Mounting Base
3
3
16
"
[80mm]
Push Buttons Keypads Strikes Magnetic Locks Key Switches Relays & Timers Access Control
5502 Timberlea Blvd.,
Mississauga, ON Canada
L4W 2T7
www.camdencontrols.com
Toll Free: 1.877.226.3369
File: Lazerpoint CM-TXLFB.indd- Rev1
Revised: 16/09/2015
Part No: 40-82B162
Page 2 of 2
Loading...