Camden Door Controls CM-43CP, CM-440, CM-47S, CM-55CBL, CM-660 User Manual

CM-69S & CM-47S

5502 Timberlea Blvd.
Mississauga, Ontario L4W 2T7
905-366-3377 Toll Free: 877-226-3369
www.camdencontrols.com

Installation Instructions

1.

Locate the 4 pilot holes in the enclosure. They are not
drilled all the way through so that you may drill your
own holes to match an existing layout or the site conditions

2.

Drill 4 X 5/32” (minimum) holes through the base.

3.

Mark the drilling locations on the wall with a pencil or
center-punch.

4.

Remove the base assembly and drill holes in the wall.
Insert the appropriate wall fasteners.

5.

Fasten the base assembly to the wall with the supplied
screws

6.

a. If using radio controls, insert the 9V mounting clip (CM-69 only)
for the battery and use the double sided tape or velcro
to secure the transmitter.
b. If hard-wiring, use one of the supplied knock-outs to
bring the wiring into the box.

Installation Instructions

Battery and transmitter not included.
Must be ordered separately.

7.

Hand insert and turn the two 6-32 screws supplied with
the switch. Install wiring connectors to the switch, center,
and place the switch over the two screws.

8.

Tighten the screws firmly using the allen key
provided with switch.

IMPORTANT! As you tighten the screws, ensure the
switch stays centres in the opening and does not rub
on the inside edge of the housing.

Parts Included:
9V battery mounting clip (CM-69 only)
4 X 6-32 self-tapping screws
4 solid wall anchors

File: CM-69S & CM-47S
Revised: March 17, 2009
Part No: 40-82B058