Cambridge SoundWorks NEWTON M60, NEWTON M80 User Manual
M50, M60 and M80 Speakers
User Manual
™
®
3
INTRODUCTION
Thanks for choosing a Newton Series speaker.
The M50, M60 and M80 all feature the finest drivers,
precision internal crossover circuitry, and an elegant
enclosure design.
The Design Team at Cambridge SoundWorks believes
there is no better combination of audiophile-level
attention to detail and reasonable cost.
AFTER UNPACKING
Store the shipping carton and packing material for
future use and transport.
CONTENTS
M50
1. One pair of speakers
2. Eight rubber feet
3. Two 3/4" long 1/4" x 20 phillips head screws
M60
1. One pair of speakers
2. Eight rubber feet
M80
1. One speaker
2. Four rubber feet
3. Allen wrench
INSPECTING FOR DAMAGE
Examine each part carefully for shipping damage. If
there is any, do not install or use the speakers. Return
the speaker to the store or merchant where you made
the purchase or call Cambridge SoundWorks at
1-800 FOR-HIFI (1-800-367-4434) for assistance.
Front Back
Rubber Feet
3/4" long 1/4"—20
phillips head screws
(M50 only)
+
—
8 Ohms
M50
Made in China
+
—
8 Ohms
M60
Made in China
HIGH
RANGE
LOW
RANGE
HIGH
RANGE
LOW
RANGE
+
—
—
+
FULL
RANGE
INPUT
8 Ohms
M80
Made in China
M50
Front Back
M60
Front Back
M80
Allen Wrench
4
Mounting the M50 on a wall:
There is a metal insert in the back of the M50 with
1/4-20 threads. The recommended bracket (avail-
able from Cambridge SoundWorks) is the Vogel’s
®
Satellite 5 (part number A1SAT5BL for black or
A1SAT5WH for white). For stability, the speaker
should be installed on the wall inverted, so the
bracket is above the speaker’s center (fig.1).
Attaching the bracket: Place the inverted speaker
on a flat surface. Attach the Multi-Position Adapter
and the upper half of the Speaker Bracket to the
M50’s threaded insert as shown in figure 2, using the
3/4” 1/4-20 Philips head screw that comes with the
speaker. Tighten securely. Attach the lower half of
the Speaker Bracket as described in the instructions
that come with the speaker bracket.
Attaching the M50 to the Newton Series
floor stands:
Follow the assembly and wire routing instructions
that come with the stands. Be sure to use the plastic
washer (supplied with the stands) between the stand
bracket and the back of the speaker as shown.
SPEAKER PLACEMENT
+
—
8 Ohms
M50
Made in China
Figure 1
Wall Mounting Options for M50
+
—
8 Ohms
M50
Made in ChinaMade in China
Figure 2
Speaker Bracket for M50
Stand Mounting for M50
Plastic Washer
(supplied with stands)
Mounting Knob
(supplied with stands)
Threaded Insert
Multi-Position
Adapter
Upper Half of
Speaker Bracket
1/4"—20 x 3/4" long
Loading...