Cambridge SoundWorks MicroWorks II User Manual
User Manual
33
4
Introduction ................................................................4
Carton Contents..........................................................5
Setup Options..........................................................6-7
Connection Diagram ..............................................8-9
Positioning Your Speakers ..................................10-11
Connections ........................................................12-15
Operation and Final Adjustment ..............................16
Specifications ..........................................................17
TABLE OF CONTENTS
INTRODUCTION
Thanks for choosing the MicroWorks II Multimedia
Speaker System. It features the finest drivers, precision
internal crossover and amplifier circuitry and an ele-
gant enclosure design.
The main left and right speakers feature magnetic
shielding, allowing placement near any sensitive elec-
tronic devices.
The Product Development Team at Cambridge
SoundWorks believes there is no better combination of
audiophile-level attention to detail and reasonable cost.
Inspecting For Damage
Examine the speaker system carefully for shipping
damage. If there is any, do not install or use the sys-
tem. Return the speaker to the store where you made
the purchase or call Cambridge SoundWorks at:
1-800 FOR-HIFI (1-800-367-4434) for assistance.
After Unpacking
Store the shipping carton and packing material for
future transport needs.
QUICK SETUP
If you have connected amplified subwoofer/satellite
systems before, the Connection Diagram on pages 8-9
may be all you need to get set up and operating.
5
CARTON CONTENTS
A
B
E
C
F
G
H
No.10 screws and
plastic anchors
D
A) Two Satellite Loudspeakers
B) Desktop Stands,Thumb screws (installed on satellites)
C) Wallmount hardware, Self-adhesive Feet
D) Hook and Loop fastener (for volume control, if not
used on Desktop Stand)
E) One Subwoofer/Amplifier Loudspeaker
F) Power Adapter (AC to AC)
G) Volume On/Off Control
H) 2 Satellite Connection Cables (2-meters)
Rubber Feet
Green to signal source
Blue to subwoofer
SETUP OPTIONS
Cambridge SoundWorks, Inc. supplies screws and plastic
anchors for convenience, but it is the speaker purchaser’s
responsibility to insure that any speaker mounting or
placement is secure, stable and reliable. Cambridge
SoundWorks assumes no responsibility for damage to its
products or any damage to property resulting from speaker
positioning or placement.
SUBWOOFER/AMPLIFIER
The Subwoofer/Amplifier requires no assembly.
SATELLITES
Desktop Placement
Each satellite is shipped with a Desktop Stand installed.
You can also mount the Volume Control to a Desktop Stand
(see page 12).
Shelf Placement (or other flat surface) without the
Desktop Stand
A) Desktop Stand Removal: unscrew the thumbscrew to
release the satellite.
B) Apply the soft, self-adhesive feet to the bottom surface
of each satellite, as shown.
Wall Mounting With Supplied Hardware
Note: Use the “hook and loop” fastener to secure the
volume control to a convenient flat surface if not using the
Desktop Stand
C) Apply the soft, self-adhesive feet to the back of the
satellite as shown. The feet provide mounting stability
and protect the finish of both the wall and the satellite.
D) Install the No.10 screw and anchor in the wall so that its
screwhead protrudes about 3/8 inch.
E) Adjust the screw so each satellite can be hung with just
a small amount of pressure.
6
Apply Feet to
Bottom for Flat
Surfaces
Apply Feet to Back
for Wall Mounting on
Screwhead
Install
Mount Speaker
A
B
D
C
E
Loading...