Cambridge SoundWorks MC300IW User Manual
MC300IW In-Wall LCR Loudspeaker
Installation and User Manual
™
®
2
3
INTRODUCTION
Thanks for choosing a Newton Series loudspeaker.
The MC300IW features the finest drivers and a
precision crossover network in a space-saving
in-wall format.
The Product Development Team at Cambridge
SoundWorks believes there is no better combination of
audiophile-level attention to detail and reasonable cost.
After Unpacking
Store the shipping carton and packing material for
future use and transport should you ever need to
return the speaker for service.
Inspecting For Damage
Examine each part carefully for shipping damage. If
there is any, do not install or use the system. Return
the speaker to the store or merchant where you made
the purchase or call Cambridge SoundWorks at 1-800
FOR-HIFI (1-800-367-4434) for assistance.
About This Manual
Care in speaker placement and installation pays dividends in optimum enjoyment. This manual provides
tips and instructions to help you get the most from
your loudspeakers. Please read through it carefully
before proceeding with the installation.
Installing the MC300IW is straightforward and may be
performed by an experienced do-it-yourself homeowner. However, some familiarity with typical home construction is necessary.
This manual assumes the installer possesses skill in
the proper use of hand and power tools, a knowledge
of local fire and building codes, and a familiarity with
the area behind the surfaces where the speakers are
to be installed.
4
If you do not posess the necessary skills or are otherwise not comfortable with performing a speaker system installation, we strongly recommend you rely on a
qualified home entertainment system installer. Contact
your dealer, or Cambridge SoundWorks for assistance
in selecting a suitable installer.
Note: Cambridge SoundWorks will not assume any
responsibility for the intrgrity of the attachment of the
speaker and itís mounting brackets to a wall or ceiling.
The quality of the installation is solely the responsibility
of the installer.
Cambridge SoundWorks is not responsible for any
damage resulting from the installation or installation
process, or due to wiring or materials used in the
installation.
Tools Required
1. Stud Finder
2. Pencil
3. Drill with 1/4" bit
4. Utility knife, jigsaw, drywall router, or other means of
cutting a hole in the mounting surface
5. Wire cutter and/or stripper for preparing
speaker wires
6. #1 Phillips screwdriver
Loading...