Cambridge DE67398684PKGORBNH, CAM398684PKGORB, CAM398684PKGCP, CAM398684PKGBN User Manual
684-398
Before begining, read the instructions below and follow all local
plumbing and building codes.
For this installation of your new freestanding faucet it is presumed
that the water supply lines are underneath the floor and are in
direct access for faucet installation.
A A rounded hole, 1-1/2β in diamter, will provide access to the water
supply lines when mounting the faucet. The distance between the
mounting location to the water supply lines should be
approximately 7β.
Unpack and inspect your new faucet for any shipping damages and
ensure no pieces are missing.
If any damages are discovered DO NOT INSTALL.
SHUT OFF ALL SHUT OFF ALL WATER SUPPLY LINES AT THE TUB W HEN
INSTALLING NEW FAUCET.
Please contact customer service at 1(866)448-Tubs. You may also
call our customer service for any other assistance with out products.
TOOLS AND MATERIALS NEEDED :
Screwdriver PlumberΚΌs Tape Adjustable wrench
1. Assuming your free standing water lines are
prepared. Locate two risers and thread them onto the
water lines.
2. Tighten these down and ensure they are both facing
the desired direction for installation.
3.3.Take each of the swing arms provided and thread
them onto the open ends of each water line. Before
fully tightening it is important to note that the swings
arms should be centered between the waterlines
approximately 3 3/8β apart.
4. Taking only the body of the faucet, attach
the body to both swing arms and center the
body. Tighten the swing arm and faucet
together.
5. Thread the spout onto the top of the faucet
body.
6. Remove the nut behind the spout to show a
cone rubber washer. Thread the stand onto the
faucet body with the rubber cone washer remain-
ing in the faucet.
7. Attach the short end of the hose to the stand with
the black washer that is tied to the hose. Now
attach the opposite end to the shower wand. Attach
the shower head to the wand as well.
8. Take the three handles and locate the shower
handle. Place and screw this handle onto the
venter of the faucet body. The HOT/COLD
handles will go on the ends of the faucet body.
HOT on the LEFT and COLD on the RIGHT.
Loading...