Cambridge CAM398463PKGORB, CAM398463PKGBN, CAM398463PKGCP User Manual

398-463

For this installation of your new freestanding faucet it is presumed that

the water supply lines are underneath the floor and are in direct access for

faucet isntallation

7”.

1. Assuming your water lines are prepared.
Locate a threaded nipple, one silver metal washer,

1. Assuming your free standing water lines are

and a washer nut from the deck mounting kit. Slide the

prepared. Locate two risers and thread them onto the

metal washer down the nipple and thread the washer

water lines.

nut onto the straight end of the nipple.

2. Tighten these down and ensure they are both facing

2. Place 2. Place the threaded nipple through the deck holes in
the desired direction for installation.

the tub and tighten the bolt from the water line onto
the straight end of the nipple. Make sure you have a

3.3.Take each of the swing arms provided and thread

rubber cone washer and gold ring washer in the nut

them onto the open ends of each water line. Before

before tightening.

fully tightening it is important to note that the swings
arms should be centered between the waterlines
approximately 3 3/8” apart.

4. Taking only the body of the faucet, attach
the body to both risers. Tighten the risers and
faucet together.

Screwdriver Plumberʼs Tape Adjustable wrench

5. Remove the nut behind the spout to show a
cone rubber washer. Thread the stand onto the
faucet body with the rubber cone washer
remaining in the faucet.

6. Attach the short end of the hose to the stand with
the black washer that is tied to the hose. Now
attach the opposite end to the shower wand. Attach
the shower head to the wand as well.

7. Test your new faucet by turning on the water
and ensuring that both HOT and COLD water
come out and that the faucet is leak free.

TEST YOUR NEW FAUCET BY RUNNING HOT AND

COLD WATER TO ENSURE THEY ARE W ORKING

PROPERLY W ITHOUT LEAKS.