Cambiatta CM1 Users Manual

Rhein Tech Laboratories, Inc. Client: Cambiatta
360 Herndon Parkway Model: Cambiatta CM1
Suite 1400 Standards: FCC 15.209
Herndon, VA 20170 Report Number: 2005067
http://www.rheintech.com

Date: May 3, 2005

APPENDIX G: MANUAL

Please refer to the following pages.

18 of 26

Parts

Diagram 1

Quick Release

Handlebar Mount

Diagram 2

Speed Sensor

and

Magnet

Installation

Diagram 3

User Manual

Thank you for your purchase of Cambiatta. You are now
ready to begin the quick start installation and set-up procedures.
Please follow these simple steps to insure proper installation and
set-up of your device and software.

Functions and features

1. The Cambiatta hardware device captures and stores
speed, cadence, and heart rate data displayed by your
current cycle computer and HRM which can then be
downloaded to your computer for analysis on Cambiatta
software.

2. Cambiatta Basic Software, once downloaded and
registered, gives you the ability to archive ride data to
maximize your training with the following features:

Parts List - Parts are pictured. (Diagram 1)

o Logs rides
o Compares archived ride data
o Highlights areas for improvement
o Tracks speed, cadence, distance, heart rate and

more than 15 critical training elements for
analysis.

Cadence Sensor

and

Magnet

Installation

Diagram 4

Properly Installed

Magnets

and

Sensors

Diagram 5

Cambiatta Unit Quick Ties (not shown)

Speed & Cadence Sensors USB Cradle and Cable

Wheel Magnet Handlebar Mount

Crank Magnet Batteries Pre-Installed

Installation and Set-up Instructions

A. Hardware Installation & Mounting:

1. Attach quick-release handlebar mount to handlebar
positioned with double ridge away from rider. Use
black rubber band to adjust fit as shown in
Diagram 2.

2. Attach Speed Sensor to left chain stay with quick
ties as shown in Diagram 3.

3. Attach Wheel Magnet to spoke on rear wheel.
Adjust Wheel Magnet and Speed Sensor such that
they are aligned as shown in Diagram 3. Note:
Must be within 3-5 mm. Once aligned, tighten both
to prevent movement.4. Attach Cadence Sensor to
left chain stay with quick ties positioned to align
with Crank Magnet as shown in Diagram 4

4. Attach Crank Magnet to inside of crank such that it
aligns with Cadence Sensor as shown in Diagram