CALIFORNIA MICRO DEVICES
CALIFORNIA MICRO DEVICES
VGA PROTECTION AND TERMINATION NETWORK
PAC VGA-100/101
Features
7 channel ESD protection
15KV ESD protection (HBM)
Application
ESD protection for VGA (video) port in
PCs and notebooks.
8KV contact, 15KV air discharge ESD protection per
IEC 1000-4-2 (Level 4)
Low loading capacitance, 4.5pF typical
Product Description
The PAC VGA-100/101 acts as a transmission line terminating and ESD protection device. It provides 75 Ohm parallel
terminations for the R, G, B lines and series terminations for the Horizontal and Vertical Sync lines and two monitor ID
lines which provide Plug and Play logic signals. In addition, all interface lines provide Level 4 ESD protection per the
IEC1000-4-2 contact discharge Specification. The PAC VGA-100 provides internal pull-up resistors for the two monitor ID
lines. The PAC VGA-101 omits these internal pull-ups so that different pull-up resistor values can be added externally.
ABSOLUTE MAXIMUM RATINGS
Diode Forward DC Current
(Note 1) 20mA
SCHEMATIC CONFIGURATION
Storage Temperature -65°C to 150°C
Operating Temperature Range 0°C to 70°C
DC Voltage at any Channel Input VN-0.5V to VP+0.5V
Note 1: Only one diode conducting at a time.
R1=75Ω, R2=33Ω, R3=2.2KΩ (VGA-100 only)
Typical Connection Diagram
(*) R3 Removed (VGA-101 only)
(**) For best ESD protection, minimize trace lengths between PAC VGA-100/101 and the video connector.
©1999 California Micro Devices Corp. All rights reserved.
©1999 California Micro Devices Corp. All rights reserved.
P/Active® is a registered trademark and PAC is a trademark of California Micro Devices.
1 / 99
1/ 99
215 Topaz Street, Milpitas, California 95035 Tel: (408) 263-3214 Fax: (408) 263-7846 www.calmicro.com
215 Topaz Street, Milpitas, California 95035 Tel: (408) 263-3214 Fax: (408) 263-7846 www.calmicro.com
C0170997D
1
1
CALIFORNIA MICRO DEVICES
PAC VGA-100/101
SNOITACIFICEPSDRADNATS
retemaraP.niM.pyT.xaM
egatloVylppuSgnitarepOV(
)V5.5
PV-N
ecnarelot)1R(rotsisernoitanimretB/G/R %5±
ecnarelot)2R(rotsisernoitanimretseireS %5±
ecnarelot)3R(rotsiserrotsiserpu-llupDIrotinoM %01±
,egatloVdrawroFedoiDI
F
C°52=T,Am02=V56.0V59.0
C°52=T,egatlovnwodkaerbesreveredoiD
000 otedohtaC(edoiDpoTV
000 otedonA(edoiDmottoBV
)
P
)
N
V0.71
V0.52
noitcetorPDSE
41dna11,9,7sniptaegatloVegrahcsiDkaeP
000 5103dohteM,ledoMydoBnamuH
000 metsys-nI
000 5103dohteM,ledoMydoBnamuH
000 2-4-0001CEIrepegrahcsiDtcatnoC
)6etoN(
,01,6,5,3,2sniptaegatloVegrahcsiDkaeP
51,21
)2etoN(
)4,3setoN(
)5etoN(
VK4-VK4+
VK51-VK51+
VK8-VK8+
C°52=T,MBHDSEVK51@egatloVpmalClennahC
.)4,3setoN(
51,21,01,6,5,3,2snipta
000 stneisnartevitisoP
000 stneisnartevitageN
C°52=T,tnerruCegakaeLlennahC Aµ1.0Aµ0.1
)zHM1@derusaeM(ecnaticapaCtupnIlennahC
.51,21,01,6,5,3,2snipta
V
P
V,V5=
N
,V0=V
TUPNI
V5.2=
Fp5.4Fp7
gnitaRrewoPegakcaP
000 egakcaPPOSQ Wm008
Note 2: From I/O pins to VP or VN only. VP bypassed to VN with 0.2 µF ceramic capacitor.
Note 3: Human Body Model per MIL-STD-883, Method 3015, C
Note 4: This parameter is guaranteed by characterization.
Note 5: Standard IEC1000-4-2 with C
Note 6: These pins are not connected directly to the video connector, and therefore are not subject to direct ESD strikes.
Discharge
=150pF, and R
Discharge
=100pF, R
Discharge
=330Ω, VP=5V, VN=GND.
Discharge
=1.5KΩ, VP=5V, VN=GND.
VP+V0.31
V
-V0.31
N
Application Information: See California Micro Devices Application Note AP-209 Design Considerations for ESD Protection
NOITAMROFNIGNIREDROTRAPDRADNATS
egakcaPrebmuNtraPgniredrO
sniPelytSsebuTleeR&epaTgnikraMtraP
61POSQT/001-AGVCAPR/001-AGVCAP001AGVCAP
61POSQT/101-AGVCAPR/101-AGVCAP101AGVCAP
©1999 California Micro Devices Corp. All rights reserved.
2
215 Topaz Street, Milpitas, California 95035 Tel: (408) 263-3214 Fax: (408) 263-7846 www.calmicro.com
1 / 99