California Faucets Wall Tub Spout User Manual

/4”
Installation Instructions
Solimar
TS-70-70
Wall Tub Spout
CALIFORNIA FAUCETS RECOMMENDS THAT ALL PLUMBING PRODUCTS BE INSTALLED
BY A LICENSED PROFESSIONAL
IMPORTANT: Read all instructions prior to installation and provide copy of instructions to consumer. Operating Specifications:
Recommended Supply Pressure: 20 to 70 psi Flow Rate (at 60 psi): 10 gpm
If water pressure exceeds 70 psi, install a Pressure-Reducing Valve (RPV).
INSTALLING SPOUT
Prior to installing spout in-wall fittings and rough
valve must be properly installed and wall surface must be completely finished
Ø1-1
Recommended through-hole size shall be Ø1-1/4”
Apply thread sealant to both threaded ends of
NIPPLE (2), not supplied, and tighten into supported ELBOW (1)
IMPORTANT: QUICK CONNECT (3) must sit inside wall 5/8” min to 1” max, to properly secured SPOUT (6) to QUICK CONNECT (3). This may be achieved by selecting proper NIPPLE (2) length.
Securely tighten QUICK CONNECT (3) onto end
of NIPPLE (2) using I/2” open-end wrench
Place O-RING (4) into ESCUTCHEON (5) & slide
ESCUTCHEON (5) onto QUICK CONNECT (3)
IMPORTANT: To prevent damage to internal o-ring on SPOUT (6), QUICK CONNECT (3) must
Slide SPOUT (6) onto QUICK CONNECT (3),
align ESCUTCHEON (5) & SPOUT (6) and tighten SETSCREW (7) on bottom side of SPOUT (6)
, not supplied
be free of any dirt and/or debris
Must sit inside wall 5/8” min to 1” max
TS-70-70_ii_120119.doc Pg 1
SPECIFICATION DIMENSIONS
w
TS-70-70_ii_120119.doc Pg 2
ww.calfaucets.com 5271 Argosy Ave. Huntington Beach, CA 92649 800-822-8855
Loading...