California Faucets Tile Styledrain Set with No-Hub User Manual

9190, 9190-3, 9190-IP-2, 9190-IP-3,

Installation Instructions

StyleDrain

9190-ABS & 9190-PVC

StyleDrain® Tile™

(patent pending)

CALIFORNIA FAUCETS RECOMMENDS THAT ALL PLUMBING PRODUCTS BE INSTALLED

BY A LICENSED PROFESSIONAL

IMPORTANT: Read all instructions prior to installation and provide copy of instructions to consumer. This installation instructions sheet is a guide for installing StyleDrain waterproofing material MUST be followed to achieve proper installation and meet all code requirements

Mortar

ood Sub-floo

ood Sub-Floor Concrete Sub-Floor

Mortar Morta

Floo

Joist

Tile™, all local building and plumbing codes as well as manufactures

Collar Up Collar Down

Tile

aterproo

Membrane

Mortar

Concrete

Earth/Ground

9190_ii_121022.doc Pg 1

All figures show 2” cast iron no-hub connection

INSTALLING DRAIN BODY

• Connect BODY (1) to pre-installed DRAINPIPE (3)

via one of the following connections which are not included:

o 2” Cast Iron No-Hub use 2” no-hub SLEEVE (2) o 3” Cast Iron No-Hub use 3” no-hub sleeve o 2” or 3” Cast Iron IPS use 2” or 3” pipe nipple o 2”/3” ABS use ABS solvent cement o 2”/3” PVC use PVC solvent cement

NOTE: It may be necessary to trim excess DRAINPIPE (3) to obtain proper final installation height

• For wood sub-floor installations the following cut hole

sizes shall be made to properly support the installed drain BODY (1):

o Ø 6-1/4” for ALL cast iron bodies o Ø 7-5/8” for ALL ABS and PVC bodies

• Perform leak test in accordance with local building &

plumbing codes before proceeding

• For proper support on drain BODY (1) use one of

the following methods based on installation type:

o Wood sub-floor: provide framing support of drain

BODY (1) and strapping of DRAINPIPE (3)

Ø6-1/4” (Cast Iron)

Ø7-5/8” (ABS/PVC)

o Concrete sub-floor: backfill with dirt and concrete

around drain BODY (1)

INSTALLING WATERPROOFING

NOTE: All waterproofing materials shall be installed per manufactures instructions and local building & plumbing codes. The following is a guide as to how waterproofing relates to the StyleDrain

• Loosen or remove BOLTS (4) and remove COLLAR

(5) from drain BODY (1)

• Use MORTAR (6) or similar to achieve proper

drainage (generally ¼” per linear foot) then apply WATERPROOFING (7) on top of MORTAR (6)

• Reattach COLLAR (5) in either down or up position

based on desired height requirements and/or local building & plumbing codes, tighten BOLTS (4) to secure COLLAR (5) into place

NOTE: When COLLAR (5) is installed in up position an additional 7/8” in height is achieved

IMPORTANT: It is necessary that WEEP HOLES (5a) are open and free of WATERPROOFING (7)

IMPORTANT: Perform water leak testing of WATERPROOFING (7) per manufactures and local building & plumbing codes requirements

Tile

™

9190_ii_121022.doc Pg 2

+ 2 hidden pages