California Faucets Solima Widespread Faucet User Manual

Widespread Lavatory Faucet

Installation Instructions

Solimar™

CF-7002

CALIFORNIA FAUCETS RECOMMENDS THAT ALL PLUMBING PRODUCTS BE INSTALLED

BY A LICENSED PROFESSIONAL

IMPORTANT: Read all instructions prior to installation and provide copy of instructions to consumer.
Operating Specifications:

Recommended Supply Pressure: 20 to 70 psi
Maximum Flow Rate: 1.5 gpm

* Operating pressures between hot and cold supplies should vary no more than 30 psi.
† If water pressure exceeds 70 psi, install a Pressure-Reducing Valve (RPV).

INSTALLING SPOUT TO SINK/DECK

• Sink/Deck recommended hole size shall be Ø1-3/8”

*†

• Place O-RING (3) into BASE (2) and sliding BASE

(2) onto spout SHANK (1a)

• Insert spout SHANK (1a) though sink/deck hole

• Slide small O-RING (5) about half way down onto

LIFTROD (4). (this will allow liftrod to be in place
for mounting, but not interfere with tightening of
spout hardware)

• Slide LIFTROD (4) through rear hole of BASE (2)

• From underside, place SLOTTED WASHER (6)

onto spout SHANK (1a) and tighten SPOUT (1)
into place with NUT (7)

• Insert RUBBER WASHER (8) into TEE (9) and

attach to spout SHANK (1a). TEE (9) should be
tighten to create watertight seal and positioned to
allow ease of attachment of valve hoses

Ø1-3/8”

CF-7002_ii_110914.doc Pg 1

INSTALLING VALVE

• From underneath insert VALVE (10) though

appropriate sink/deck hole

IMPORTANT: VALVES (10) are labeled as follows:

BLUE is COLD left turning (counter-clockwise) closed

RED is HOT right-turning (clockwise) closed

• Position flange NUT (11) and WASHER (12) so

that VALVE (10) extends 1-3/8” above sink/deck
surface

• Insert O-RING (3) into ESCUTCHEON (13) and

place onto VALVE (10)

• Secure ESCUTCHEON (13) onto sink/deck by

tightening lock NUT (14)

ALIGNMENT OF BASES

• Use a ruler or straight edge to align the spout base

and escutcheons of the faucet as shown

• After alignment retighten lock nuts and spout nut

1-3/8”

CF-7002_ii_110914.doc Pg 2