California Faucets Roman Tub Sets 73 User Manual
Tel: 714-891-7797
Fax: 714-891-2478
Toll Free: 800-822-8855
www.calfaucets.com
7208 & 7308
ROMAN TUB SET
INSTALLATION
INSTRUCTIONS
IMPORTANT
Due to the thin wall tubular design of this spout, please note the following
Spout is not meant to be used as a support or grab device. Any excessive weight, pulling or grabbing of spout may
cause damage or injury and will void the warranty.
It may be necessary to initially operate at full flow, then reduce the flow to retain the desired “sheet” flow effect at
lower operating water volume.
California Faucets reserves the right to make modification and specification changes at any time.
Please visit www.calfaucets.com for most current technical data.
NOTE:
-The manufacturer recommends
the use of hard piping (not flex
connections) for all connections.
-It is also recommended that an
access panel be provided for
all Roman Tub installations.
"A" MIN
:
#7208
"A" = 3/4"
THROUGH-HOLE
SPOUT:
VALVE:
1-1/4"
1-1/4"
Fig. 1
HOT INLET
COLD INLET
***NOTE: SHUT OFF WATER SUPPLY BEFORE BEGINNING INSTALLATION***
1
Install spout
(See Fig. 2)
:
-Remove NUT, WASHER, & SPACER from SHANK.
-Apply thread sealant to spout inlet NIPPLE.
-Tighten SHANK onto NIPPLE firmly.
-Insert SPOUT through deck/tub hole.
-Place SPACER (if necessary), WASHER, & NUT onto SHANK.
-Align SPOUT and tighten NUT firmly.
-Apply thread sealant to end of SHANK.
#7308
"A" = 1"
THROUGH-HOLE
SPOUT:
VALVE:
1-1/4"
1-1/4"
SPOUT
BASE
NIPPLE
SPACER
WASHER
NUT
RT_7208_ii_101220
Fig. 2
SHANK
P1
Install valve bodies
2
NOTE:
-Remove top nut and discard.
-Turn bottom nut with fiber washer down the valve until it stops.
-Place spacer cup onto valve oriented correctly as shown.
-Insert valve through hole from below.
-Attach and thread escutcheon onto threads below stem and
adjust valve to scheduled height "A".
-Place handle onto stem allowing minimal gap between escutcheon and
handle. Tighten setscrews with Allen key provided.
-Align handle in desired position and tighten the bottom nut to secure valve.
Hot & cold valves are labeled:
NOTE: Align square escutcheon on 7202 Series prior to securing valve.
(See Fig. 1 & 3)
RED
:
= hot &
BLUE
= cold.
Escutcheon
Sink/
Countertop
Spacer Cup
Fiber Washer
Bottom Nut
OUTLET
"A"
7202 Series
"A" = 3/4"
7302 Series
"A" = 1"
Valve
Fig. 3
Piping:
3
-Use rigid copper piping (not included) to connect hot & cold valves to tee & water supply
Flexible hoses are not recommended for the following reasons:
1. Hoses may be inaccessible and require occasional replacement;
2. Some trim installations require escutcheon to hold valve in place.
WARNING: To prevent damage to valve all soldering shall be performed before attaching fitting directly to valve.
Any additional soldering should be performed at least 6" away from valve ports.
(See Fig. 1).
INLET
RT_7208_ii_101220
P2
Loading...