California Faucets PB-R Extension User Manual
CALIFORNIA FAUCETS RECOMMENDS THAT ALL PLUMBING PRODUCTS BE INSTALLED BY A LICENSED PROFESSIONAL
If pressure balance trim does not attach to the installed valve because the valve is positioned too far into the finished wall, these extension
kits will extend the valve’s cartridge nut an additional ½”, 1” or 1-½” to allow installation of originally supplied trim.
Each kit contains the following:
½”, 1” or 1-½” Extension Kit for Pressure Balance Valve PB-R
EXT-PB05 EXT-PB10 EXT-PB15
EXT-PB05, EXT-PB10 & EXT-PB15
Installation Instructions
REMOVE BUSHING FROM CARTRIDGE NUT
• Remove BUSHING (2) from installed valve’s
CARTRIDGE NUT (1) as shown
INSTALL EXTENSION KIT EXT-PB05
• Attach EXTENSION SLEEVE (3) onto CARTRIDGE
NUT (1)
• Attach BUSHING (2) onto EXTENSION SLEEVE
(3)
• See .3. INSTALL TRIM
EXT-PB-R_ii_110128.doc Pg 1
/
INSTALL EXTENSION KIT EXT-PB10
A
• Attach two (2) EXTENSION SLEEVE (3) onto
CARTRIDGE NUT (1)
• Attach BUSHING (2) onto EXTENSION SLEEVE
(3)
• See .3. INSTALL TRIM
INSTALL EXTENSION KIT EXT-PB15
• Attach three (3) EXTENSION SLEEVE (3) onto
CARTRIDGE NUT (1)
• Attach BUSHING (2) onto EXTENSION SLEEVE
(3)
• Remove SCREW (4) and STEM (5a) from valve
• Attach EXTENDED STEM (5b) to valve using
SCREW (4)
• See .3. INSTALL TRIM
INSTALL TRIM
• Place SHOWERPLATE (6) onto BUSHING (2)
• Tighten ESCUTCHEON (7a) onto BUSHING (2)
until SHOWERPLATE (6) is secure to finished wall
surface. An additional BONNET (7b) may be
supplied based on product style, this BONNET
(7b) shall be attached to ESCUTCHEON (7a)
prior to affixing HANDLE (8)
½”
1
”
32
• Trim STEM (5) to allow ½” of STEM (5) to
protruded out from ESCUTCHEON (7)
• Place HANDLE (8) onto STEM (5)
• Allow for
1
/32” (thickness of credit card) of gap
between ESCUTCHEON (7) and HANDLE (8)
• Tighten SETSCREW (9) to secure HANDLE (8)
onto STEM (5)
www.calfaucets.com 5231 Argosy Ave. Huntington Beach, C
EXT-PB-R_ii_110128.doc Pg 2
92649
800-822-8855
Loading...