California Faucets Miramar 8 Widespread User Manual

CF-4802 & CF-4802X

Widespread Lavatory Faucet

Installation Instructions

Miramar™

CALIFORNIA FAUCETS RECOMMENDS THAT ALL PLUMBING PRODUCTS BE INSTALLED

BY A LICENSED PROFESSIONAL

IMPORTANT: Read all instructions prior to installation and provide copy of instructions to consumer.
Operating Specifications:

Recommended Supply Pressure: 20 to 70 psi
Maximum Flow Rate: 1.5 gpm

* Operating pressures between hot and cold supplies should vary no more than 30 psi.
† If water pressure exceeds 70 psi, install a Pressure-Reducing Valve (RPV).

INSTALLING SPOUT TO SINK/DECK

*†

• Sink/Deck recommended hole size shall be Ø1-3/8”

• Attach RING (2) onto BASE (3) and slide onto

spout SHANK (1a)

• Insert spout SHANK (1a ) though sink/deck hole

• From underside, place SLOTTED WASHER (4)

onto spout SHANK (1a) and tighten SPOUT (1)
into place with NUT (5)

• Insert RUBBER WASHER (6) into TEE (7) and

attach to spout SHANK (1a)

IMPORTANT: TEE (7) should be tighten to create watertight seal
and positioned to allow ease of attachment of valve hoses

CF-4802_ii_120821.doc Pg 1

Ø1-3/8”

INSTALLING VALVE

• From underneath insert VALVE (10) though

appropriate sink/deck hole

IMPORTANT: VALVES (10) are labeled as follows:

BLUE is COLD left turning (counter-clockwise) closed

RED is HOT right-turning (clockwise) closed

• Position flange NUT (9) and WASHER (8) so that

VALVE (10) extends 2-5/16” above sink/deck
surface

• Attached RING (2) onto ESCUTCHEON (11)

• Place ESCUTCHEON (11) onto VALVE (10) and

secure to sink/deck surface

INSTALLING HANDLE

• Loosen SETSCREW (12c) from HANDLE (12a or

12b)

• Slide HANDLE (12) down onto and engage valve

STEM (10a)

• Allow a minimum gap (1/32”) between HANDLE

(12) and ESCUTCHEON (11), tighten SETSCREW
(12c)

IMPORTANT: To obtain proper alignment it may be necessary to

rotate VALVE (10) so that HANLDE (12) is aligned to desired
orientation

2-5/16”

CF-4802_ii_120821.doc Pg 2