California Faucets Deluxe Arm for Large Showerheads User Manual

/4”

Installation Instructions

Solimar™

SH-570

Shower Arm

CALIFORNIA FAUCETS RECOMMENDS THAT ALL PLUMBING PRODUCTS BE INSTALLED

BY A LICENSED PROFESSIONAL

IMPORTANT: Read all instructions prior to installation and provide copy of instructions to consumer.
Operating Specifications:

Recommended Supply Pressure: 20 to 70 psi
Flow Rate (at 60 psi): 10 gpm

† If water pressure exceeds 70 psi, install a Pressure-Reducing Valve (RPV).

INSTALLING SHOWER ARM

• Prior to installing shower are in-wall fittings and

rough valve must be properly installed and wall
surface must be completely finished

†

Ø1-1

• Recommended through-hole size shall be Ø1-1/4”

• Apply thread sealant to both threaded ends of

NIPPLE (2), not supplied, and tighten into
supported ELBOW (1)

IMPORTANT: QUICK CONNECT (3) must sit inside wall 5/8” min
to 1” max, to properly secured SHOWER ARM (6) to QUICK
CONNECT (3). This may be achieved by selecting proper NIPPLE (2)
length.

• Securely tighten QUICK CONNECT (3) onto end

of NIPPLE (2) using I/2” open-end wrench

• Place O-RING (4) into ESCUTCHEON (5) & slide

ESCUTCHEON (5) onto QUICK CONNECT (3)

IMPORTANT: To prevent damage to internal o-ring on SHOWER
ARM (6), QUICK CONNECT (3) must
debris

• Slide SHOWER ARM (6) onto QUICK CONNECT

(3), align ESCUTCHEON (5) & SHOWER ARM
(6) and tighten SETSCREW (7) on bottom side of
SHOWER ARM (6)

, not supplied

be free of any dirt and/or

Must sit inside wall
5/8” min to 1” max

SH-570_ii_120119.doc Pg 1

INSTALLING SHOWER HEAD

w

• Attach SHOWERHEAD (8), not supplied, onto

SHOWER ARM (6)

SPECIFICATION DIMENSIONS

SH-570_ii_120119.doc Pg 2

ww.calfaucets.com 5271 Argosy Ave. Huntington Beach, CA 92649 800-822-8855