California Faucets Craftsman Styledrain Set with No-Hub User Manual

™

StyleDrain

decorative shower drain systems

(Patent Pending)

INSTALLATION INSTRUCTIONS

Model #9170
#9170-3
#9170-ABS
#9170-PVC-2

Model #9171
#9171-3
#9171-ABS
#9171-PVC-2

9170_INSTL_090619.doc Pg. 1

All figures show cast iron no-hub connection

• California Faucets recommends this product be installed by licensed contractor(s)

• To avoid damage, store decorative grid in safe and secure place, Grid should be installed after all flooring is completed.

CONNECTING TO DRAIN PIPE
Note: Sub floor height and depth may vary depending

on location and type. Install the drain according to type
of application. For wood flooring cut the following sized
hole in flooring based on body material:

• 6-1/4” diameter for cast iron drain body

• 7-5/8” diameter for ABS or PVC drain body

1. Connect drain BODY [1] to pre-installed DRAINPIPE
[3] with trap in the floor using:

• No-Hub connector SLEEVE [2] (not included) for

cast iron body.

• ABS plastic pipe solvent cement for ABS body.

• PVC plastic pipe solvent cement for PVC body.

Note: Body may have ½” NPT primer connection on side of body.
If primer not required, insert PLUG (not included) into body.

2. Perform a leak test in accordance with local building
& plumbing codes.

Concrete sub-flooring

• For proper support of drain back fill around drain
with dirt and concrete.

Wood sub-flooring

• For proper support of drain brace and strap drain
and piping.

(see figure 1)

(see figure 1)

(see figure 1 & 2)

Pg. 2 9170_INSTL_090619.doc