Califone PI30, PI39 User Manual

Page 1
CAUTION
RISK OF ELECTRIC SHOCK - DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER OR
BACK. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QAULIFIED
PERSONNEL.
!
The lightening ash with arrowhead within a triangle is intended to tell the user that parts inside the product are a risk of electric shock to persons.
This product is not designed to function normally in strong electro-
magnetic elds. Consequently, the
product is exposed to strong electromagnetic elds. Normal audio quality operation will be recovered when the strong electromagnetic eld is no longer present.
audio quality may degrade while the
IMPORTANT SAFETY INSTRUCTIONS
ATTENTION: ALL SAFETY AND OPERATING INSTRUCTIONS SHOULD BE READ BEFORE OPERATING APPLIANCE. ALL OPER­ATING AND USE INSTRUCTIONS SHOULD BE FOLLOW­ED WHEN OPERATING THE APPLIANCE. HEED AND ADHERE TO ALL WARNINGS ON THE APPLIANCE AND IN THE OPERATING INSTRUCTIONS. RETAIN ALL SAFETY AND OPERATING INSTRUC­TIONS FOR FUTURE REFERENCE.
WATER & MOISTURE - DO NOT USE THE APPLIANCE NEAR WATER; IE. BATHTUB, WASHBOWL, KITCHEN SINK, LAUNDRY TUB, WET BASEMENT OR SWIMMING POOL.
VENTILATION - DO NOT SITUATE THE APPLIANCE SO THAT ITS LOCATION OR POSITION INTERFERES WITH ITS PROPER VENTILATION. FOR EXAMPLE, THE APPLIANCE SHOULD NOT BE SITUATED ON A BED, SOFA, RUG OR SIMILAR SURFACE THAT MAY BLOCK THE VENTILATION OPENINGS. THE APPLIANCE SHOULD NOT BE PLACED IN A BUILT-IN INSTALLATION, SUCH AS A BOOKCASE OR CABINET, THAT MAY IMPEDE THE FLOW OF AIR THROUGH THE VENTILATION OPENINGS.
HEAT - SITUATE THE APPLIANCE AWAY FROM HEAT SOURCES SUCH AS RADIATORS, HEAT REGISTERS, STOVES OR OTHER AP­PLIANCES (INCLUDING AMPLIFIERS) THAT PRODUCE HEAT.
POWER SOURCES - CONNECT THE APPLIANCE ONLY TO A POWER SUPPLY TYPE DESCRIBED IN THE OPERATING INSTR­UCTIONS OR MARKED ON THE APPLIANCE.
GROUNDING OR POLARIZATION - PRECAUTIONS SHOULD BE TAKEN SO THAT THE GROUNDING OR POLARIZATION MEANS OF THE APPLIANCE ARE NOT DEFEATED.
!
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, SO NOT EXPOSE THIS APPLIANCE
TO RAIN OR MOISTURE.
POWER CORD PROTECTION - POWER SUPPLY CORDS SHOULD BE ROUTED SO THAT THEY ARE NOT LIKELY TO BE WALKED ON OR PINCHED BY ITEMS PLACED UPON OR AGAINST THEM, PAY­ING PARTICULAR ATTENTION TO CORDS AT PLUGS, CONVENIENCE RECEPTACLES, AND THE POINT WHERE THEY EXIT FROM THE APPLIANCE.
CLEANING - THE APPLIANCE SHOULD BE CLEANED ONLY AS REC­OMMENDED BY THE MANUFACTURER.
NON USE PERIODS - UNPLUG THE APPLIANCE POWER CORD FROM THE OUTLET WHEN LEFT UNUSED FOR A LONG PERIOD OF TIME.
OBJECT & LIQUID ENTRY - CARE SHOULD BE TAKEN SO THAT OBJECTS DO NOT FALL AND LIQUIDS ARE NOT SPILLED INTO THE ENCLOSURE THROUGH OPENINGS.
DAMAGE REQUIRING SERVICE - THE APPLIANCE SHOULD BE SER­VICED BY QUALIFIED SERVICE PERSONNEL WHEN: (A) THE POWER SUPPLY CORD OR THE PLUG HAS BEEN DAMAGED (B) OBJECTS HAVE FALLEN OR LIQUID HAS BEEN SPILLED INTO THE APPLIANCE (C) THE APPLIANCE HAS BEEN EXPOSED TO RAIN (D) THE APPLI­ANCE DOES NOT APPEAR TO BE OPERATING NORMALLY OR EXHIB­ITS A MARKED CHANGE IN PERFORMANCE (E) THE APPLIANCE HAS BEEN DROPPED OR THE ENCLOSURE DAMAGED.
SERVICING - THE USER SHOULD NOT ATTEMPT TO SERVICE THE APPLIANCE BEYOND THAT DESCRIBED IN THE OPERATING INSTRUCTIONS. ALL OTHER SERVICING REFER TO A QUALIFIED SERVICE PERSONNEL.
The exclamation point within a triangle is intended to tell the user that important operating and servicing instructions are in the papers with the appliance.
Ce produit n’est pas conçu pour
un fonctionnement dans de forts
champs électromagnétiques. Par conséquent, la qualité sonore peut
un fort champ életromagnétique. La qualité sonore redeviendra normale après affaib-lissement du champ électromagnétique.
diminuer si ce produit est exposé à
Series
Field Array Speaker
Owner’s Manual
PI39 16-Channel UHF Powered Speaker
PI30-PS Powered Speaker
PI30-SP Non-Powered Speaker
Califone® International Inc. • 1145 Arroyo Avenue, # A • San Fernando, CA 91340 USA Toll Free 800.722.0500 | Toll Free Fax 877.402.2248 International Customers call 818.407.2400 or Fax 818.407.2405 califone.com
Califone PI30/PI39 Rev 01 0609
califone.com
Page 2
PI39
PI30/PI39 Series Field Array Speaker
Owner’s Manual
Thank you for purchasing this PI30/PI39 Series Field Array Speaker.
We encourage you to visit our websites, www.califone.com and www.califonepro.com, to register your product for its warranty coverage, to sign up to receive our newsletter, download our catalog, and learn more about the complete line of Califone audio vi­sual products, including portable and installed wireless PA systems, multimedia players and recorders, headphones and headsets, computer peripheral equipment, visual presentation products and language learning materials.
Unpacking
Check carefully for damage which may have taken place during transit. Report any damage claim directly to the freight carrier immediately. If there is any damage, save the product and packaging for inspection by the carrier’s claim agent. Notify your dealer of the pending claim.
Warranty Registration
Please register for your 6-year warranty online at www.califone.com to activate your warranty.
Service Repairs
Should your unit require repair contact the dealer or Califone Service Department at: (800) 722-0500 to obtain a Return Authorization number. After receiving the RA, ship the unit to Califone prepaid. Collect shipments will be refused.
Contents
a) Field Array Speaker
b) AC/DC power adapter (only for use with PI39 and PI30-PS)
c) Mounting bracket with assembly hardware
d) Owner’s Manual
1 6  C H A N N E L U H F
P O W E R E D
F I E L D A R R A Y
S P E A K E R
S P E C I F I C A T I O N S
11
UHF channel selector
1
DC In jack (2)
2
1/4” microphone jack (2)
3
1
2
3
4
5
6
7
8
5
9
3
2
10
Audio line-out with variable volume control
4
Audio line-in RCA jacks (2)
5
Volume on/o and volume control
6
Power on LED
7
Tone control
8
Audio line-out with xed volume control
9
Wireless receiver power on/o and volume
10
Audio and UHF LEDs
11
1 2
Page 3
PI30-PS
PI30-SP
P O W E R E D
F I E L D A R R A Y
S P E A K E R
S P E C I F I C A T I O N S
N O N  P O W E R E D
F I E L D A R R A Y
S P E A K E R
S P E C I F I C A T I O N S
Wall Mounting of any PI30/PI39 Series Field Array Speaker
1
2
3
4
5
6
4
7
2
1
WARNING
Improper installation can cause serious injury. Use only industry approved mounting methods and hardware. Califone cannot be responsible for improper installation or subsequent damage.
DC In jack (2)
1
1/4” microphone jack
2
Audio line-out with variable volume control
3
Audio line-in RCA jacks (2)
4
Volume on/o and volume control
5
Tone control
6
Audio line-out with xed volume control
7
1
Clamping of any PI30/PI39 Series Field Array Speaker
WARNING
Improper installation can cause serious injury. Use only industry approved mounting methods and hardware. Califone cannot be responsible for improper installation or subsequent damage.
Spring-loaded terminals
1
3 4
Page 4
Setup and Operation for Powered Array Speakers (PI39 and PI30-PS)
Power Plug the power adapter into a standard AC outlet and the DC plug into either of the DC jacks on the rear of the speaker.
Specications
Microphone
For use with a cabled microphone, plug the mic into one of the 1/4” phone jacks before turning on the power. Turn the power ON (the red LED will light) and adjust the volume to the desired level while speaking into the microphone.
Line-In
Two pair of RCA jacks are provided to connect audio from CD, LCD Projector or other audio sources. The Left and Right channels are “summed” because the speaker system is monaural.
Fixed and Variable Line Outs
Both the PI39 and PI30-PS have xed and variable volume line out features. With these two features, you can not only daisy chain additional speakers for wider audio distribution, but also support functioning of an independent system (supporting special needs students for example.) Both line outputs are the same audio mix as what’s being output by the speaker itself. Which output is used depends on where you prefer to control the volume from.
Fixed The xed line output level is not aected by the main volume control.
Variable The variable line output level varies with the volume control setting.
Tone Control
The tone control would normally be set at 12 o’clock and will have little eect when using a microphone. When playing music turning the control clockwise will increase the treble, while turning counter clockwise will increase the bass.
LED Indicators
There are two LED indicators behind the speaker grille. Red indicates that there is a UHF transmission signal from the microphone. The green lights when audio is being transmitted.
PI39 16-Channel UHF Powered Speaker Only
The PI39 can receive wireless audio from any 900MHz Califone UHF transmitter (PA919SD, PA919, and wireless mics).
Wireless Receiver
If using a Califone wireless transmitter, rst make sure the transmitter and PI39 speaker are set to the same frequency. Turn on the receiver power and adjust the volume to 10 o’clock. Then turn the speaker power and adjust the volume level to 10 o’clock.
Wireless Microphones
There are two wireless microphone transmitters for use with the PI39; Q319 handheld microphone and M319 beltpack transmitter used with your choice of exible collar mic (CM-316), headset mic (HBM-316), and lapel mic (LM-316).
Q319 Install battery and switch ON the Microphone. Wait 5 seconds prior to talking into the microphone. Adjust
the UHF receiver volume and speaker volume to the desired level.
M319
Install battery. Plug in one of the three available microphones. The M319 has a volume control which should be set at the lowest level before turning on the power. After turning the power ON gradually increase the volume to a comfortable level. As with the handheld microphone there is a 3-5 second delay before transmitting.
Speaker System (PI39, PI30-PS and PI30-SP)
Power Capacity 30 Watts RMS power capacity, 6 Ohms impedance Sound Pressure Level: 93 dB, 1 Watt @ 1 Meter Dispersion: -3dB @ 120 degrees o axis Frequency Response: 250Hz to 12KHz Transducers: Three each 3.5” Diameter, High Energy Neodymium Magnets (shielded), 10 Watts RMS capacity 3/4” Dia. Voice Coil, 16 Ohm
Amplier: 15 Watts RMS @ 5% THD Power Source: 100-240 volt AC universal power supply 12 VDC to amplier
Dimensions: 12” H x 5” W x 4” D
Weight: Speaker 3 lbs. Bracket 1.3 lbs.
Compliance: Power Adapter CE, C-UL
PI39 Only
Wireless System
Receiver: One 16 channel selectable UHF diversity wireless receivers 902 - 928 MHz. Antennas are hidden internally.
Microphone Transmitters: Handheld wireless microphone or beltpack transmitters optional.
PI39 and PI30-PS
Line In Line level RCA jacks (2) providing for audio input from CD, Tuner, LCD projector via cable.
Line Outs Fixed and variable, RCA (2).
Mic. In 1/4” jack for microphones with a cable.
Microphone Lockout
Two wireless microphones cannot be used at the same time unless one is turned o while the other is being used. Otherwise the rst to be turned on will block out the other.
NOTES Turn the transmitter power switch o when not being used to minimize battery drain.
5 6
Loading...