Cal Flame BBQCR07900E User Manual
LTR20081037, Rev. B
6/20/08
This manual applies to the Cal Flame Electric
Grill, model BBQ07871E and the Cal Flame
Electric Grill Cart, model BBQCR07900E.
Instructions For Installation ...........1
Proper Electric Supply ....................1
Supply Connection .......................1
Save these instructions!
Read all instructions before you
operate your grill.
Cabinet Cut-out Dimensions................1
Connecting Power to the Grill or Cart ........2
Safety Instructions ...................3
Using Your Electric Grill
Heating Elements.........................5
Grill Operation ...........................5
..............5
Care and Maintenance ................ 6
Cooking Grates ..........................6
Hood and Body ..........................6
Storage .................................6
Drip Pan ................................6
Care of Stainless Steel ....................6
Covering Your Cart or Grill .................6
After Use Care ...........................6
Electric Grill Wiring Diagram........... 8
Warranty Information ................10
Copyright 2007-2008 Lloyds Material Supply, Inc.
All rights reserved. Duplication without written
consent is strictly prohibited.
Cal Flame™ is a registered trademark.
Due to continuous improvement programs, all
models, operation, and/or specications are
subject to change without prior notice.
LTR20081037, Rev. B
6/20/08
CONTACT INFORMATION
For customer service, please contact your
authorized dealer immediately. If you need
additional information and/or assistance,
please contact:
L.M.S. Customer Service Department
1462 East Ninth Street
Pomona, CA 91766.
Toll Free: 1-800-CAL-SPAS
Fax: 1-909-629-3890
Instructions For Installation
Proper Electric Supply
Save these instructions for local electrical inspector’s
use.
You must provide an adequate electrical supply system
as required for your grill. All wire connections must be
in accordance with local codes and properly insulated.
Check with local utility for governing electrical codes
and ordinances. In absence of local electrical codes,
the National Electrical Code, NFPA No. 70, must be
followed. A copy of the National Electrical Code, NFPA
No. 70, can be obtained by writing to:
National Fire Protection Association
Batterymarch Park
Quincy, Massachusetts 02269
It can also be found at the NFPA web site at www.nfpa.
org.
Your 240V electric grill is required to have a dedicated
30 amp breaker with three #10 AWG copper wires. This
will include a black and a red wire for your incoming
power and a green wire for your ground. Electrical
service should only be wired by a licensed electrician.
Breakers vary in appearance and wire locations. Before
wiring load and feed wires to the breaker, verify they are
being connected to the proper poles.
When determining a suitable location, consider factors
such as exposure to wind, proximity to trafc paths, and
windows that open into the home.
Locate barbecue grills and stainless steel carts only in
well-ventilated areas and only on solid, at foundations
(e.g. deck or cement slab). Do NOT place stainless steel
carts on dirt or grass.
Cabinet Cut-out Dimensions
Your Cal Flame™ grill is designed for easy installation
into a non-combustible enclosure. The supporting deck
or counter must be at and level. When determining the
nal location of your grill, adequate cross ventilation
must be present to prevent gas from being trapped in
the event of a leak.
The drawings below show the cabinet cut-out dimensions
you will need.
Width Depth Height
23 ¼” 22 ¼” 9 1/4”
Always follow applicable local, state, and federal codes
and guidelines.
Supply Connection
All electrical connections are to be protected from the
elements and be in accordance with local codes for
outdoor wiring. This appliance is to be permanently
wired.
Most cities and counties require permits for exterior
construction and electrical circuits. In addition, some
communities have codes requiring residential barriers
such as fencing and/or self-closing gates on property to
prevent unsupervised access to the property by children
under the age of ve. Your dealer can provide information
on which permits may be required and how to obtain
them prior to the delivery of your equipment.
We recommend the installation, adjustment and service
of your new grill be performed by L.M.S. qualied
installers and service technicians to ensure proper
operation and prevent accidents.
2008 Electric Grill Owner’s Manual Page 1
LTR20081037, Rev. B
Connecting Power to the Grill or Cart
These instructions apply to both the 220V electric grill and grill cart.
Owners of the 220V electric grill cart will need a second person to help them.
Lift the grill up from the cart and bring it forward about 10 to 12 inches. You will see a small electrical junction 1.
box behind the grill.
Grill owner’s do not need to do this. When have removed all packaging from the grill, place the grill on a solid
surface. The junction box will be accessible directly behind the grill.
2.
Using a Phillips head screwdriver, remove the screws from
the access plate.
Remove the brass caps on the 4.
sides of the junction box and
insert the power cables.
Attach power cable to wires in 5.
junction box with twist-on wire
connectors.
Insert a 220V power cable through one of 3.
the holes in the back (left or right side).
Replace the cover. For cart owners, 6.
carefully move the grill back into
place.
Page 2 2008 Electric Grill Owner’s Manual
LTR20081037, Rev. B
Loading...