cahors CAP5510 Instructions Manual

INSTRUCTIONS

Digital Terrestrial Programmable Amplifiers

CAP5510

REF. 0145056R13

CS 60022 • 46003 Cahors cedex 9 - France
Tél. [phone] • Fax [phone]

www.cahors-ced.com
www.groupe-cahors.com

SUMMARY

DESCRIPTION

1 / Presentation

2 / Programming

INSTALLATION

1 / Wall assembly

2 / Connecting the antennas

PROGRAMMING

1 / Power

2 / LTE filter programming

3 / Configuration

4 / Programming of the filters

5 / Deactivation of unused filters

6 / UHF input attenuator setting

7 / Setting of the cross fader floor

8/ B.I + FM, B.III/DAB and AUX input setting

9 / TV supply of the inputs

10 / Automatic Equalization and output level adjuster

11 / PassCode tamper

12 / Reset of the Central

13 / Precautions for use

DESCRIPTION

2

1 / Presentation:

The CAP5510 is a programmable amplification for analog and digital channels central
land.

The control unit can be programmed to select the frequency range of UHF 21-69
input / 21-60 (Lte 4 G) / 21-48 (Lte 5 G) and it allows to amplify 10 filters UHF with a
capacity of 1 to 7 channels each. These filters are divided into input 2 connectors. The
setting for the number of filters assigned to the entries is done by the programming
keypad or software (Windows o Android).

It is also equipped with B.I + FM, B.III/DAB, entries to the amplified.

The plant has a maximum gain of 55 dB UHF, each input can be attenuated by 20 dB if
the levels at the terminals of the antennas are too high, and each filter has a dynamic
of 30 dB programmatically setting in increments of 1 dB. The Central also benefits
from a general mitigation inter floor 20 DB through programming and 1 dB steps.

The programming is easy thanks to the display on the successive screens of all parameters
(filter no., mitigation, channel upper and lower) of the filter being adjusted.

Cut-off filters not used, in order to reduce the current consumption and to avoid the
residual noise.

Transistors low noise are used for the floors of entries and transistors to high output and
low intermodulation are used for the output stages.

2 / Programming:

Central CAP5510 offers 3 different, but equivalent, for programming all parameters.

3

a) By means of a built-in Scheduler consists of a keyboard and a display which is

located on the central part.

b) by using a graphics software for PC

Windows compatible (connecting through
the USB from the central door).

c) By a tablet with operating system Android 4.0 or successive. The application is

optimized for tablet with screen from 5 "to 10".

Correct operation requires that the tablet is equipped with a USB port which is
authorized to the modality On The Go (OTG).

The latest tablets, produced by the major companies are normally provided.

For a correct connection must be used an adapter USB - OTG cable.

4