MODEL 9406
LOW WATTAGE WARM AIR CIRCULATOR
PROPAGATEUR D’AIR CHAUD À FAIBLE CONSOMMATION EN WATTS
CIRCULADOR DE AIRE CALIENTE DE BAJO VATAJE
OPERATING INSTRUCTIONS
INSTRUCTIONS DE FONCTIONNEMENT
INSTRUCCIONES DE OPERACIÓN
9406CA-ABX - 120V AC, 60Hz
9406CA230-ABX - 230V AC, 50Hz
(Do not use with 220V AC, 60Hz)
Stor-Dry™ Model 9406 - SAVE THESE INSTRUCTIONS
The Stor-Dry Warm Air Circulator combats mold and mildew by reducing the amount of
moisture available for spores to grow and multiply. This is accomplished using a unique
dual action that utilizes both a low wattage heating element and a fan to circulate air.
Operating Instructions
Simply plug the unit into the appropriate outlet. Red LED indicates when unit is
operating. Make sure that airfl ow is not restricted. The heater has been designed for
continuous operation. Current draw is less than a 100 watt light bulb.
NOTE: The key to keeping any area free of moisture is proper ventilation.
CAUTION! Surface is hot, avoid contact.
WARNING: In order to avoid overheating, do not cover the heater.
Care and Maintenance
The Stor-Dry™ requires very little maintenance. By following the instructions within this
manual the heater will operate problem-free for years.
Unplug unit before cleaning. A vacuum can be used to clear the heater of any dust
build-up and a dry cloth may be used to wipe the outer surface.
Do not attempt to open the unit to clean.
Specifi cations
120 Volts, 60Hz, 0.65A, 75 Watts
230 Volts, 50Hz, 0.33A, 75 Watts
Operation
An internal blower pulls cool, damp air in the bottom and releases warm dry air through
the top. Active air circulation technology raises the ambient temperature above the dew
point to control mold and mildew. Designed for low
cost continuous use.
The amount of water vapour air can hold (absolute
humidity) increases with temperature. The Stor-Dry™
low wattage heating element slightly warms the
room’s air to keep the moisture suspended rather than
condensing on surfaces where mold spores can use it
to grow.
Secondly, the Stor-Dry™ fan keeps a small amount of
air moving throughout the room to help prevent any
moisture from condensing on surfaces to again impede
the growth of mold spores.
Important Instructions
When using electrical appliances, basic precautions should always be followed to reduce
risk of fi re, electric shock, and injury to persons including the following:
1. SAVE THESE INSTRUCTIONS.
2. Read all instructions before using the heater.
3. Caution: High temperature. This heater is hot when in use. To avoid burns, do not
let bare skin touch hot surfaces. Keep combustible materials, such as furniture,
pillows, bedding, papers, clothes and curtains at least 3 feet from the front of the
heater and away from the sides and rear.
4. Extreme caution is necessary when any heater is used by or near children or
disabled persons and whenever the heater is left unattended while in operation.
5. Always unplug heater when not in use.
6. Do not operate any heater with a damaged cord or plug or after the heater
malfunctions, has been dropped or damaged in any manner. Return heater to
authorized service facility for examination, electrical or mechanical adjustment or
repair.
7. Do not use outdoors.
8. This heater is not intended for use in bathrooms, laundry areas and similar indoor
locations. Never locate heater where it may fall into a bathtub or other water
container.
9. Do not run cord under carpeting. Do not cover cord with throw rugs, runners or the
like. Arrange cord away from traffi c area and where it will not be tripped over.
10. To disconnect heater, remove plug from electrical outlet.
11. Connect heater to an appropriate electrical outlet which meets the electrical ratings
as marked on the heater.
12. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as
this may cause an electric shock, fi re, or damage to the heater.
13. To prevent a possible fi re, ensure air intakes and exhaust are free from obstructions.
Do not use on soft surfaces, like a bed, where openings may become blocked.
14. Do not use it in areas where gasoline, paint or fl ammable liquids or materials are
used or stored.
15. Do not use in areas where there is a risk of build-up of fl ammable materials.
16. Use this heater only as described in this manual. Any other use not recommended
by the manufacturer may cause fi re, electric shock, or injury to persons.
17. The heater must not be located immediately below a socket-outlet.
18. WARNING: This heater has a polarized plug (one blade is wider than the other).
As a safety feature, this plug will fi t in a polarized outlet only one way. If the plug
does not fully fi t the outlet, reverse the plug. If it still does not fi t consult a qualifi ed
electrician. Never use with an extension cord if the plug cannot be fully inserted. Do
not attempt to defeat this safety feature.
Stor-Dry™ Modèle 9406
VEUILLEZ CONSERVER CES DIRECTIVES
Le propagateur d’air chaud Stor-Dry™ lutte contre les moisissures en réduisant
l’humidité relative de l’air qui permet aux spores de croître et de multiplier. Pour
cela, le Stor-Dry™ fait appel à la fois à un élément chauffant à faible puissance et à un
ventilateur pour renouveler l’air.
Instructions de fonctionnement
Il suffi t de brancher l'unité dans la prise appropriée. Le voyant DEL rouge indique que
l’unité est en cours de fonctionnement. Veiller à ce que l'air puisse circuler librement.
Ce modèle a été conçu pour un service en permanence. Il consomme moins d'electricité
qu'une ampoule de 100 watts. REMARQUE: Une bonne aération est primordiale pour
combattre l'humidité!
«ATTENTION» Surface chaude. Évitez tout contact.
«ATTENTION» Afi n d’éviter une surchauffe, ne pas couvrir le radiateur!
Entretien et maintenance
Le Stor-Dry™ requiert une maintenance minimale. Si vous respectez les consignes de ce
manuel, votre chaufferette fonctionnera pendant plusieurs années sans problème.
Débranchez la chaufferette avant de la nettoyer. Vous pouvez utiliser un aspirateur
pour la dépoussiérer et un chiffon sec pour la nettoyer en surface.
Ne tentez pas d’ouvrir l’appareil à nettoyer.
Fiche technique
120 Volts, 60Hz, 0.65A, 75 Watts
230 Volts, 50Hz, 0.33A, 75 Watts
Utilisation
Un ventilateur interne aspire l’air humide et froid par le bas
et souffl e de l’air chaud et sec par le haut. La technologie de
circulation active de l’air permet de relever la température
ambiante au-dessus du point de rosée pour mieux contrôler
la formation de moisissures. Conçu pour une utilisation en
continu particulièrement économique.
La quantité de vapeur d’eau que contient l’air (humidité
absolue) augmente avec la température. En réchauffant
légèrement l’air d’une pièce ou d’une cabine, le Stor-Dry™
maintient l’humidité en suspension dans l’air plutôt que de la condenser sur les surfaces
où les spores de moisissure commencent à se développer.
Deuxièmement, le Stor-Dry™ maintient une petite quantité d’air en mouvement dans
la pièce pour aider à évaporer l’humidité pouvant se condenser sur les surfaces, pour
prévenir toute nouvelle croissance des spores de moisissure.
Loading...