Caframo Chinook, Chinook 707, Chinook 707CH-WBX, Chinook 707CH-BBX Operating Instructions Manual

MODEL 707
707CH-WBX white/blanc 707CH-BBX black/noir
2 SPEED ELECTRIC FAN
VENTILATEUR ÉLECTRIQUE À 2 VITESSES
OPERATING INSTRUCTIONS
INSTRUCTIONS DE FONCTIONNEMENT
Caframo Limited
501273 Grey Road 1, RR 2, Wiarton, Ontario, Canada, N0H 2T0
Toll Free: 1-800-567-3556 | Phone: 519-534-1080 | Fax: 519-534-1088
www.caframo.com
READ AND SAVE THESE INSTRUCTIONS Operation
To operate the fan, depress the switch to “II” for HI, “I” for LO and “0” for off. The blade must be clear of any obstructions that would cause it to jam.
Important Safety Instructions
• To reduce the risk of fi re or shock, do not use this product with any
solid-state speed control device (dimmer switch).
• This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electrical shock, this plug is intended to fi t in a polarized outlet one way. If the plug does not fi t fully in the outlet, reverse the plug. If it still does not fi t, contact a qualifi ed electrician. Do not attempt to defeat this safety feature.
• Unplug fan before cleaning.
• Use common sense when using this and/or any electrical appliance.
• Do not position too close to any objects which may be drawn into the blades and stop the airfl ow.
• Do not use outdoors, on wet surfaces or immerse in water. Never allow water to drop into motor housing.
• Do not use if power supply cord becomes frayed or brittle.
• Do not use gasoline, thinners or other harsh chemicals to clean fan.
• Do not position too close to fi replaces or stoves to avoid damage to plastic parts.
Warning! Avoid prolonged jamming of the fan blade. This model is
equipped with an “overheat protector” which is designed to stop the motor if the fan blade is jammed for a long period of time. Under extreme conditions damage can occur to the blade at the point where it attaches to the shaft. If damaged, the blade will not be secure on the shaft and will have to be replaced. Please contact Caframo Customer Service at 1-800-567-3556 for a replacement blade.
Care and Maintenance
This product has been designed for many years of problem-free operation. There are however, a few simple things that you can do to enhance the life of your fan:
1. Keep the air vents clear and free of dirt. These vents are necessary to keep the motor cool while in use. Unplug the fan, and use a vacuum to remove dirt from vents.
2. Although this product has self- lubricating bearings, after many years of use these can dry out and clog with dust. Should this happen, your fan will begin to run slower, louder and may seize-up. To prevent this, unplug the fan, blow out and lubricate the front bearings where indicated in the diagram beside. Use a light machine oil.
The front bearing is easily oiled by turning the fan so that the shaft is vertical with the blade facing upwards. Remove the blade by fi rmly pulling it straight off the shaft. Apply a couple of drops of oil onto the shaft, as close to the bearing as possible, and leave adequate time for the oil to penetrate the bearing. Clean the shaft thoroughly before replacing the blade.
Caution! Keep out of the reach of children.
Specifi cations
120 volts, 60 Hz, 0.35 Amps 6 ft. cord (1.83 m)
Loading...
+ 5 hidden pages