Cadi Scientific TSS900 User Manual

TSS-800/900 ThermoSENSORTM Wireless Temperature Sensor
User Guide
Cadi Scientific Pte Ltd
Federal Communications Commission (FCC) Statement
15.21
You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Operation is subject to the following two conditions:
1) this device may not cause interference and
2) this device must accept any interference, including interference that may cause undesired
operation of the device.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
COPYRIGHT
Specifications are subject to change without notice. Copyright © 2003 Cadi Scientific Pte Ltd. All rights reserved.
Cadi Scientific Pte Ltd 1003 Bukit Merah Central #04-40 Singapore 159836 Singapore
http://www.cadi.com.sg
2
Cadi Scientific Pte Ltd
Introduction
The TSS-800/900 ThermoSENSORTM is a wireless temperature sensor for measuring a patient’s body temperature. It is part of the SmartSense Wireless Integrated Sensing System – a system designed for monitoring of vital signs, tracking of the location of people and equipment, contact-tracing between people, and providing alert notification of people or equipment that has arrived at designated locations.
The ThermoSENSORTM is to be attached to patients’ body, at the lower abdomen area, with the use of a comfortable and hypoallergenic dressing, such as the 3M Tegaderm, to continuously measure patient’s body temperature.
Every 30 seconds, the sensor will take a temperature measurement and transmits the measured temperature to the SMN-800/900 SmartNODE.
3
Loading...
+ 4 hidden pages