Cable Electronics 1001ST User Manual

Theater 1001ST

Audio/Video Stereo Modulator

1001ST

Information Brochure

True MTS compatible stereo output

Distributes a Video/Audio Source to multiple

locations over a single coax cable.

Cable Electronics, Inc.

3209 Wood Drive
Garland, Texas 75041

[phone] Fax [phone]

DVD Player / Video Game / Camera / Etc.

AUDIO Right / Left

Typical application diagram.

VIDEO

TELEVISION

1001ST

F-Connector

Coax Cable

To Ant.

Or CATV

TV

1001ST

This unit allows any stereo Audio/Video source, to distribute Audio and
Video to different locations over standard coax cable. The RF output can
be changed to any channel between 14 to 69 or cable channels from 65
to 125 ( 95-99 not included).

SPECIFICATIONS

VIDEO

Nominal Input level: 1 Volt peak to peak
Input Impedance: 75 ohms
Isolation port to port: 32 dB
Isolation out to input: 60 dB
Video bandwidth: > 4 Mhz

AUDIO

Nominal Input level: 1 Volt peak to peak
Input impedance: 22k ohm
THD: < 0.5%
Frequency Response: 20Hz to 14kHz
Channel Separation: >30dB
Signal to Noise: >60dB @ 2 Volts

POWER

Requirement: External 9 Volt DC @ 250mA (minimum) with a 2.5mm
Coaxial Center positive connector. Power Supply is included.

WARRANTY

Cable Electronics, Inc. warrants this product to be free from defects in material and
workmanship, under normal use and service, for a period of one year from the purchase by
the original purchaser. If this product is defective or malfunctions, Cable Electronics will
replace or repair this unit (at their option) within a reasonable time. No expressed or implied
warranty is made for any defects caused by immersion or exposure to liquids, abuse,
neglect, improper operation of unit, excess wear and tear and defects resulting from
unauthorized disassembly and or modification.

NOTE: *Please allow one channel spacing above and below the modulator tuned channel

to prevent interference to existing channels.
*Press and hold the mode button to change the frequency output mode. Hold for
at least 6 seconds or until display changes.

1001ST

PERFORMANCE SPECIFICATIONS

And Features

Interface

Tuning Push but ton digital control
Display 2 ½ D igit , Se ven Segment Digit al R ead out
Mode Selects Off-Air or Cable output frequencies

Video

Input Level: Standard 1 Vp-p
Input Impedance: 75 ohms
Connector: RCA

Audio

Full MTS Stereo Compatibility.

Input level: Standard 1 Vp-p ( 2 Vp-p max )
Input Impedance: 22K ohm minimum
Frequency Response: 20 Hz to 14 kHz
Channel Separation: Greater than 30 dB typical
Signal to Noise: 60 dB
Distortion: Less than 0.5 %
Connector: Two RCA, Right and Left

Misc.

Channel Range: UHF 14 to 69, Cable 65 to 94, 100 to 125
RF Output Level: +20 dBmV, F connector
Power Supply: 9 to 12 Vdc, 250 mA minimum
Size: 3.9 x 3.9 x 1.5 inches
Internal Band Pass Filtering to virtually eliminate spurious signals
Stereo encoder is Macrovision compatible for use w ith DVD and VCR sources