E4 Printer Quick-start instruction manual
Step # 1. Loading the Media (Label tape) into the printer.
1. Media roll guides 3. Media spindle 5. Media holder
2. Media core adapters 4. Media roll 6. Media guides
1. Open the top cover.
2. Place the media roll (4) onto the media spindle (3).
( For media rolls with cores larger than 1-1/2" (40 mm), use the two
core adapters (2) provided )
3. Slide the two media roll guides (1) onto the media spindle, with the
smooth sides facing the media roll.
4. Place the media spindle with the media roll into the media holder
slots (5) in the printer.
( The media must unroll with the adhesive side down)
5. Position the media in the center of the media spindle and slide the media
roll guides (1) up against the media roll.
6. Release the printhead module and swing it up.
7. Feed the media under the media guide shaft (6) and pull the media
forward past the feed roller.
8. Slide the media guides (6) up against the media.
Continue to positioning the media sensor
Loading...