C2G VGA over UTP Extender- Remote Unit User Manual

TruLink™

VGA over UTP Extender- Remote Unit

USER MANUAL

Model #39961

Introduction

The TruLin k™ VGA over UTP Ex tende r Remo te Un it, whe n used with the Base U nit (p ar t #39 959
or #39960), is a robust solution that allows you to extend your VGA signal up to 300 meters
(1000 feet) over a Cat5E Unshielded Twisted Pair (UTP)cable and distribute the signal to up to
four display devices. This solution is ideal for applications where your VGA monitor needs to be
placed further than the average 100 foot VGA cable limitation and you want to split the signal to
multiple displays. Driving a VGA signal over Cat5E allows you to take advantage of your UTP
cable infrastructure already installed for a cost-effective and reliable installation.

The TruLink VGA over UTP solution is ideal for applications when you need to place your
computer in remote location. This is common in digital signage applications typical in retail stores,
houses of worship, classrooms, and board rooms where you need video presentation in one
room but want th e computer to be out of sight and in a s afe and secure e nvironment. With the
TruLink VGA over UTP Extender, you can pl ac e your displays acro ss the room, on another floor,
or in another building while your computer remains in a convenient location.

• Extend your analog video signal up to 300 meters (1000 feet)

• Distribute your video signal to up to four monitors, projectors, or other display devices

• Cat5E UTP cabling enables easy and cost effective in-wall installation

• Ideal for digital signage applications in retail stores, houses of worship, classrooms, and

board rooms

• Output Connector: HD15 Female

• Input Connector: RJ45 connector joins the Base Unit and the Remote

• Power Supply: DC 12V 600mA

• VGA signal gain and equalization length can be adjusted as necessary to improve

picture quality

• Base Unit required- sold separately

Package Contents

• TruLink VGA over UTP Extender- Remote Unit

• DC 12V 600mA Power Adapter

• User Manual

System Requirements

• Base Unit- Part #39959 or #39960 (sold separately)

• Remote Unit- Part #39961 (included)

• Cat5E UTP Cable

• HD15 connection on computer

• HD15 connection on each monitor, projector, or other display device

• HD 15 male to male cables for the computer and each display device connected