Portable bluetooth speaker
BY-AU-BS-181
SWITCH
Turn on the power: Pull the on/off key and the LED lights up to indicate that the
device is turned on.Power off: Pull on/off key, LED light off, indicating that the
device is off.
FM radio
Press the mode switch button to enter the "FM Radio"function.
Aux
Press the mode switch button to insert the 3.5mm audio cable into the"AUX"fum ctioln jack for music playback.
MEMORY CARD
Insert the memory card into the memory, card slot for m usic playback.
MEMORY CARD
Insert the Memory Card flash drive into the Memor y Card slot for music playback
BT connection
When the unit is turned on, the BT f unction is turned on.
Searching for BT devices
Then pair the device (eg phone, tablet, laptop, etc .)
BT Open matc
point you can start using it. Note: The BT pairing name is the model number.
AUX Press the mode S button to insiert the 3 .5mm audio cable into the 'AUX'
FM FM Radio Playback
BT Enable BT signal for pairing with devices compatible
Memory Card
Memory Card
hes the search connection. There is a voice point when the match in successful. At this
function jack for music playback
Audio playback from pendrive Aud io
playback from Memory card
Use the"Mode"button to select the BT/Memory Card/FM function.
MODE Use the Mode"button to select the BT/Memory Card/FM function
Rewind track to be played /Decrease Volume
Next song playback volume plus
Start track playback and Pause playback on/Scan FM Radios
●
Memory Card charging cable, one end is plugged Into the speaker mini
charging socket", the other end is plugged into the computer Memory
Card interface charging indica, tor lights up, it is charging.
●
Each charging time is about 4-6 hours, no more than 7 hours, do not use
when charging. Charge with your phone charger for no more than 5 hours.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment. This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
ϋϋ Reorient or relocate the receiving antenna.
ϋϋ Increase the separation between the equipment and receiver.
ϋϋConnect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
ϋϋ Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Loading...