Byron Home Easy HE-208 Installation Instructions Manual

RE-INVENTING THE HOME

HOME

easy

HE-208 Remote Control

Ceiling Rose & Single Gang

Light Switch

V1.0

Installation Ceiling Rose:

The HomeEasy HE-208 Remote Control
Bayonet Ceiling Rose allows and Single
gang light switch, allows you to convert a
standard single way light switch into a
2way switch, without the need for
additional wiring.
 - 100W Max Load
 - 30Metre Range

INSTALLATION WARNINGS:

BEFORE COMMENCING INSTALLATION

ISOLATE YOUR MAINS ELECTRIC SUPPLY

Read the instructions care fully before starting the installation process and keep
them for future reference. If you are in any doubt on the installation process,
consult a qualified electrician.

This product should be installed in accordance with the relevant sections of
the building
regulations code, and the current edition of the IEE Wiring Regulations
(BS 7671:Requirements for electrical installations) and appropriate statutory
regulations.

As of1 April 2004, new installations in the UK should be wired using the EU
harmonised colours for the supply conductors:
New colours:
 BROWN = Live  BLUE = Neutral Earth = Yellow/Green
Old colours:
 RED = Live BLACK = Neutral
The old colours will cease from April 2006.

Electrical installations in bathrooms, kitchens, gardens, floor and heating systems,
swimming pools, saunas and extra-low voltage lighting are classed as special
installations and must be certified and conforming to Part P, requirements of
BS 7671:2001 and appropriate statutory regulations. Contact your local Building
Regulation authority if required.

Do not install ceiling receivers on lighting circuits used to supply other
products such as extractor fans and shaver socket outlets.
Do not exceed the Maximum Power Rating of 100W, Incandescent lighting
only

Do not use the HE-206 Ceiling Rose with low voltage lighting transformers,
fluorescent bulbs, or energy saving lighting, incorrect installation may damage the
converter. In case of any doubt consult a competant electrical installer

6: Now pair the HE-206 bayonet ceiling rose with a HomeEasy Remote control HE-100,
HE-200, HE-300 or HE-102 (Not Included).

See Pairing and Deleting Remote Control.

7: Replace the ceiling rose cover making sure no wires are caught between the switch
and the wall. Do not over tighten as this could crack or distort the cover. .

1: Isolate the mains supply, then remove the existing ceiling rose.

2: Attach the HE-206 ceiling rose using the

screws provided.

3: Wire the mains cable to the HE-206 Ceiling Rose as per the
diagram opposite, making sure the Live and neutral wires are
correctly connected.
If required a breakable tab on the base can be removed.

230~240V

230 ~ 50Hz

Earth

Live

Nutral

SWITCH CABLE

ZERO VOLTAGE

5:Make sure all the cables are connected correctly and securely fastened.

4: Connect the all switch to the ceiling rose, making sure that the switch is zero

voltage.

Com

1Way

Light Switch

Ceiling Rose

Light Switch

HE-307

Ceiling Rose

HE-206

For use with 1 gang incandescent lights, indoor use only.

C H Byron
34, Sherwood Rd
Aston Fields
Bromsgrove
B60 3DR

Contact Details :

433MHz

R&TTE

APPROVED

CH Byron Electrical United Kingdom. www.chbyron.com

A

B
DK
FIN

F

D
GR

LT

IRL

I
L

NL

P
E
S

UK
BG
CZ
EST

H
IS

LV

M
N

SK
SLO
CH
PL
RO

0560

Tel: [phone]
Fax: [phone]
Web: www.chbyron.com
E-mail:
[e-mail]

Contact:   Helpline: 0845 2301 231

RF Range: The radio signals operating distance is reduced when the signal has

to pass through walls. The radio signals achieve a range of 30m inside a building;
this can be reduced depending on the type of material

TIMBER

CONCRETE

GLASS

PLASTICS

10 - 15%

BRICK

10 - 40%

40- 80%

10 - 40%

METAL

90%

5 - 15%

Range

Reduction Guide:

Help Section :

Product Specification:

Ceiling Rose: HE-206
Power: 230V~50Hz
Max Load:100W BEC14/E27
(Incandescent Lighting)
Internal Fuse: 2A, 130 degrees Celsius
Range: 30 Metres (Open Distance)
Frequency: 433.92MHz
Indoor Use Only

Switching On/Off /Dimming:

Warning: Never Exceed the Product Specification

Remote Control:

(See pairing/deleting with remote control)

On: Press on button
OFF: Press Off button

Dimming: Press "On" and then press "On" again, the Ceiling Rose unit will

now start to dim, press "On" to select the required level. To switch "Off",
press off as normal.

Standard Light Switch:
On/Off: Switch on and off as normal.
Dimming: Switch On, Off and On again. The converter will now start to dim, to

select the required level switch the light Off and On.

Using a small flat screwdriver remove the front cover by
placing the screw driver in the location notch on the
bottom part of the rocker cover and unclip the cover.

Once the location for the switch has been selected,
the wall switch can be stuck or screwed to the wall

Self Adhesive Tabs:
1: To stick the HE-307 to the wall, clean the sur face of all loose material and

grease using an appropriate cleaner (an alcohol based cleaner is recommended
for tiled surfaces).
When the surface is dry, remove the backing tabs on the double sided sticky
pads located on the back of the wall switch and press firmly against the wall.

To screw the unit to the wall:

2. Using the backing bracket as a template

mark and drill two holes and fix the bracket
securely using the appropriate screws and
wall plugs (included), make sure the arrow
faces up.

UP

Installation Light Switch:

WARNING: Attaching the HE-307 to a metallic surface will reduce
the operating distance.

Resetting Ceiling Rose:

To delete all the remote control units from the memory of the HE-206 Ceiling
Rose, hold the "Learn" button for more than 6 seconds, the LED will start to blink
continuously. Press the learn button again, the LED will blink twice to confirm
the deletion of all remote controls form the memory of the Ceiling Rose.

Pairing/Deleting With Remote Control:

Up to Six remote control Light switch's or HomeEasy
remote controls (not included), can be paired with a
single Remote Control Ceiling Rose.
To program the Remote Control Ceiling Rose install
the unit as per the instructions (See Installation),
now press the "Learn" button located inside the
ceiling rose cover.

Deleting Light Switch:

To delete a remote control that has been paired with the Remote Control Ceiling
Rose, simply press the "Learn" button. The LED will start to blink; press the "Off"
button on the remote control, the LED will blink twice to confirm that the remote
control has been removed from the memory of the Ceiling Rose.

Pairing with Light Switch:

The LED will start to flash, now press the selected "On" button on the remote control,
the LED will stop flashing. The units are now paired together. Place your selected light
bulb (max 100W) into the Bayonet Ceiling Rose (BEC14/E27), you can test this by
pressing the "ON/OFF" on the light switch

LED

LEARN

On/Dim

Off

On/Dim

Off

Changing Battery:

Replace the battery with a new CR2032 battery (Byron SX100),
making sure the polarity is correct, then replace the front
cover.

Using a small flat screwdriver remove the front cover by placing the screw driver in the
location notch on the bottom part of the rocker cover and unclip the cover.

Battery

Remote Control: HE-307
Battery: 3v Cr2032
Range: 30 Metres (Open Distance)
Frequency: 433.92MHz
Indoor Use Only