B&W Trailer Hitches RVXA3120 User Manual
B&W Trailer Hitches
1216 HWY 224 / PO Box 186
Humboldt, KS 66748
P:620.473.3664
F:620.473.3766
Call or Email us for
Installation Support
hitches@turnoverball.com
www.turnoverball.com
NOTE:
We recommend reading instructions before beginning the installation.
Installation Instructions
Model RVXA3120
RAM RV FOOT, BED SUPPORT KIT
6
5
4
2
1
3
Follow all warnings and methods described in the
companion installation instructions (model RVK3000).
Copies of these documents can be found at our web
site: www.turnoverball.com or by calling
620−473−3664.
PREPARING TO INSTALL
PARTS LIST
ITEM
1
Ram RV Foot
2
Locking Strap
5
" Carriage Bolt
3
16
5
4
" Flat Washer
16
5
5
" Lock Washer
16
5
6
" Finish Nut
16
7
Foot Pad (Not Shown)
QTYDESCRIPTION
2
4
4
4
4
4
8
INSTALL FEET
Attach Feet: Each foot can be attached by
"wrapping" the hemmed edge of the foot around the
outer flange of the base feet, see figure B1.
HEMMED
EDGE
NOTE: Remove all parts from the packaging and
familiarize yourself with all the parts required. Use the
parts list to verify that all the parts and hardware are
present.
Remove Base pads. If present, Remove the rubber
pads installed underneath the Companion base.
Install foot pads:
If your bed has a spray in bed liner
the foot pads are not required. Place four foot pads
on each foot, two pads on either end, see figure A1.
These pads will protect your bed from the sharp edges
of the steel feet.
FOOT PADS
FOOT
Figure A1
Copyright 2013, B&W Custom Truck Beds, Inc. ALL RIGHTS RESERVED
FOOT
FIGURE B1
Install hardware: Attach each foot to the
companion base with two locking straps, as shown in
figure B2. Secure the feet and the locking strap to
the base with the 5/16" carriage bolts, washers, lock
washers, and nuts provided with the kit.
LOCKING
STRAP
FOOT
Figure B2
NOTE: It is normal for the locking straps to deform
when the 5/16" hardware is tightend.
RVXA3120 06 24 2013
Loading...