Buyers CC600 User Manual

Quality since 1946

Installation Instructions

CC600 6" Conduit Carrier

Before you begin assembling the conduit carrier,
verify that you have received all the parts listed
in the bill of materials.

9049 Tyler Blvd. • Mentor, Ohio 44060

Phone [phone] • Fax [phone]

Toll-Free Fax [phone] • buyersproducts.com

Tools & Supplies Required

• 3/8" Drill and 3/8" Drill Bit

• Tape Measure

• Silicon Sealant

• 8 Cap Fasteners (rivets or nuts and bolts)

• Drill Bit for selected fastener

1. Assemble the front and rear covers to a length of 6" PVC
pipe. Apply a bead of silicon sealant (not supplied) to the
inside of the front and rear covers before sliding them over
the ends of the PVC pipe.

2. Secure the caps to the PVC pipe with either pop rivets
or screws (not supplied) in four places. Drill suitably sized
holes for your fastener through the cap and PVC pipe. Drill
the holes in the 2 o’clock, 4 o’clock, 8 o’clock and 10 o’clock
positions.

3. Determine the position on your truck or van ladder rack
that you would like to mount your new CC600 conduit car­rier. Drill two 3/8" holes on 7.0" centers in each of the ladder
rack cross rails for the U-bolts and saddles.

4. Assemble the conduit carrier assembly to the ladder rack
with the saddles, U-bolts, lock washers and nuts supplied.

Bill of Materials

item part no. qty. descrip tion

1 3006475 1 Ring, 6" Rear Cover Mount
2 3006476 1 Cover, Rear, 6" Conduit Carrier
3 - 2 Pin, Spring Roll 5/16" x 1" SST
4 3006472 1 Cap, Front, 6" Conduit Carrier
5 3006488 1 Gasket, Door, Conduit Carrier
6 - 1 Bushing, Flanged, Polymer
7 3006473 2 Saddle, 6" Conduit Carrier
8 3006474 2 U-Bolt, Round, 6-5/8" x 9-3/4" w/3" of 3/8-16 Thd.
9 3006479 1 Pin, Cover Latch, Conduit Carrier
10 - 2 Washer, 5/16" SAE SST
11 3006480 1 Spring, Compression, Conduit Carrier
12 - 1 Pin, Cotter 3/32" x 3/4" Stainless
13 - 4 Washer, Lock RHS-3/8" Zinc
14 - 4 Nut, 3/8-16 Hex ZP
n/s 3006554 1 Hardware Kit, Conduit Carrier (Items 13, 14)

Warranty

Buyers Products Co. warrants all truck/trailer hardware manufac­tured or distributed by it, to be free from defects in material and
workmanship for a period of one year from date of shipment. Parts
must be properly installed and used under normal conditions. Any
product which has been altered, including modification, misuse,
accident or lack of maintenance will not be considered under
warranty. Normal wear is excluded. The sole responsibility of
Buyers Products Co. under this warranty is limited to repairing or
replacing any part or parts which are returned, prepaid, and are
found to be defective by Buyers Products Co. Authorization from
Buyers Products Co. must be obtained before returning any part.
No charges for transpor tation or labor performed on Buyers’ prod­ucts will be allowed under this warranty.

3006555 Rev. B