Burr Brown Corporation AFE1144E-1K, AFE1144 Datasheet

1

®

AFE1144

AFE1144

AFE1144

®

HDSL/MDSL ANALOG FRONT END

FEATURES

● LOWER OUT OF BAND PSD

● SSOP-28

● PIN COMPATIBLE WITH AFE1124

DESCRIPTION

Burr-Brown’s Analog Front End chip greatly reduces
the size and cost of an xDSL (Digital Subscriber Line)
system by providing all of the active analog circuitry
needed to connect a digital signal processor to an
external compromise hybrid and line transformer. The
AFE1144 is optimized for HDSL (High bit rate DSL)
and for lower speed MDSL (Medium speed DSL) and
RADSL (Rate Adaptive DSL) applications. Because
the transmit and receive filter responses automatically
change with clock frequency, the AFE1144 is particu­larly suitable for RADSL and multiple rate DSL sys­tems. The device operates over a wide range of data
rates from 64kbps to 1168kbps.

∆Σ

Modulator

Pulse Former

Programmable

Gain Amp

Difference

Amplifier

Patents PendingAFE1144

Line Driver

txLINE

txLINE

rxHYB
rxHYB

rxLINE
rxLINE

tx and rx

Control

Registers

tx and rx
Interface

Lines

Decimation

Filter

©

1999 Burr-Brown Corporation PDS-1575A Printed in U.S.A. December, 1999

For most current data sheet and other product

information, visit www.burr-brown.com

Functionally, this unit consists of a transmit and a
receive section. The transmit section generates analog
signals from 2-bit digital symbol data and filters the
analog signals to create 2B1Q symbols. The on board
differential line driver provides a 13.5dBm signal to
the telephone line. The receive section filters and
digitizes the symbol data received on the telephone
line. This IC operates on a single 5V supply. The
digital circuitry in the unit can be connected to a
supply from 3.3V to 5V. It is housed in a SSOP-28
package.

● 64kbps TO 1168kbps OPERATION

● SCALABLE DATA RATE

● 250mW POWER DISSIPATION

● +5V POWER (5V or 3.3V Digital)

International Airport Industrial Park • Mailing Address: PO Box 11400, Tucson, AZ 85734 • Street Address: 6730 S. Tucson Blvd., Tucson, AZ 85706 • Tel: [phone]

Twx: 910-952-1111 • Internet: http://www.burr-brown.com/ • Cable: BBRCORP • Telex: 066-6491 • FAX: [phone] • Immediate Product Info: [phone]

2

®

AFE1144

SPECIFICATIONS

Specifications are at 25°C, AVDD = +5V, DVDD = +3.3V, ftx = 584kHz (E1 rate), unless otherwise noted.

AFE1144E
PARAMETER COMMENTS MIN TYP MAX UNITS
RECEIVE CHANNEL

Number of Inputs Differential 2
Input Voltage Range Balanced Differential

(1)

±3.0 V

Common-Mode Voltage AV

DD

/2 V
Input Impedance All Inputs See Typical Performance Curves
Input Capacitance 10 pF
Input Gain Matching Line Input vs Hybrid Input ±2%
Resolution 14 Bits
Programmable Gain 0dB, 3dB, 6dB, 9dB and 12dB 0 +12 dB
Settling Time for Gain Change 6

Symbol Periods

Gain + Offset Error Tested at Each Gain Range 5 %FSR

(2)

Output Data Coding Two’s Complement
Output Symbol Rate, rxSYNC

(3)

32 584 kHz

Output Bit Rate, rxSYNC

(3)

64 1168 kbits/sec

TRANSMIT CHANNEL

Transmit Clock Rate, f

tx

Symbol Rate 32 584 kHz
T1 Transmit –3dB Point T1E1 4/99 - 002R4 Draft Compliant 196 kHz
T1 Rate Power

(4, 5)

txBoost = 0 13 14 dBm
E1 Transmit –3dB Point ETSI Compliant 292 kHz
E1 Transmit Power

(4, 5)

txBoost = 0 13 14 dBm
Common-Mode Voltage, V

CM

AVDD/2 V

Output Resistance

(6)

DC to 1MHz 1 Ω

TRANSCEIVER PERFORMANCE

Uncancelled Echo

(5)

rxGAIN = 0dB, Loopback Enabled –71 –68.5 dB
rxGAIN = 0dB, Loopback Disabled –71 –68.5 dB
rxGAIN = 3dB, Loopback Disabled –74 –71 dB
rxGAIN = 6dB, Loopback Disabled –76 –73.5 dB
rxGAIN = 9dB, Loopback Disabled –78 –75.5 dB

rxGAIN = 12dB, Loopback Disabled –80 –77.5 dB

DIGITAL INTERFACE

Logic Levels

V

IH

|IIH| < 10µADV

DD

–1 DVDD +0.3 V

V

IL

|IIL| < 10µA –0.3 +0.8 V

V

OH

IOH = –20µADV

DD

–0.5 V

V

OL

IOL = 20µA +0.4 V

t

rx1

Interface 914ns

POWER

Analog Power Supply Voltage Specification 5 V
Analog Power Supply Voltage Operating Range 4.75 5.25 V
Digital Power Supply Voltage Specification 3.3 V
Digital Power Supply Voltage Operating Range 3.15 5.25 V
Power Dissipation

(4, 5)

AVDD = 5V, DVDD = 3.3V, 250 mW

Power Dissipation

(4, 5)

AVDD = DVDD = 5V 300 mW

PSRR 55 dB

TEMPERATURE RANGE

Operating

(6)

–40 +85 °C

NOTES: (1) With a balanced differential signal, the positive input is 180° out of phase with the negative input, therefore the actual voltage swing about the common­mode voltage on each pin is ±1.5V to achieve a total input range of ±3.0V or 6Vp-p. (2) FSR is Full-Scale Range. (3) The output data is available at twice the symbol
rate with interpolated values. (4) With a pseudorandom equiprobable sequence of HDSL pulses; 13.5dBm applied to the transformer (16.5dBm output from txLINEP
and txLINEN). (5) See the Discussion of Specifications section of this data sheet for more information. (6) Funtionality is guaranteed over temperature range.

3

®

AFE1144

PIN CONFIGURATION

The information provided herein is believed to be reliable; however, BURR-BROWN assumes no responsibility for inaccuracies or omissions. BURR-BROWN
assumes no responsibility for the use of this information, and all use of such information shall be entirely at the user’s own risk. Prices and specifications are subject
to change without notice. No patent rights or licenses to any of the circuits described herein are implied or granted to any third party. BURR-BROWN does not
authorize or warrant any BURR-BROWN product for use in life support devices and/or systems.

NC
NC

DV

DD

DGND

txbaudCLK

tx48xCLK

Data In

rxbaudCLK

rx48xCLK

Data Out

DV

DD

DGND

AV

DD

rxHYB–

NC
AGND
txLINE+
AV

DD

txLINE–
AGND
AV

DD

vrREFN
VCM
vrREFP
AGND
rxLINE+
rxLINE–
rxHYB+

1
2
3
4
5
6
7
8

9
10
11
12
13
14

28
27
26
25
24
23
22
21
20
19
18
17
16
15

AFE1144

Analog Inputs: Current .............................................. ±100mA, Momentary

±10mA, Continuous

Voltage.................................. AGND –0.3V to AV

DD

+0.3V

Analog Outputs Short Circuit to Ground (+25°C) ..................... Continuous

AV

DD

to AGND .........................................................................–0.3V to 6V

DV

DD

to DGND.........................................................................–0.3V to 6V

Digital Input Voltage to DGND ..................................–0.3V to DV

DD

+0.3V

Digital Output Voltage to DGND ............................... –0.3V to DV

DD

+0.3V

AGND, DGND, Differential Voltage .................................................... 0.3V

Junction Temperature (T

J

) ............................................................. +150°C

Storage Temperature Range .......................................... –40°C to +125°C

Lead Temperature (soldering, 3s).................................................. +260°C

Power Dissipation .......................................................................... 700mW

ABSOLUTE MAXIMUM RATINGS

ELECTROSTATIC
DISCHARGE SENSITIVITY

This integrated circuit can be damaged by ESD. Burr-Brown
recommends that all integrated circuits be handled with
appropriate precautions. Failure to observe proper handling
and installation procedures can cause damage.

ESD damage can range from subtle performance degradation
to complete device failure. Precision integrated circuits may
be more susceptible to damage because very small parametric
changes could cause the device not to meet its published
specifications.

PACKAGE SPECIFIED

DRAWING TEMPERATURE PACKAGE ORDERING TRANSPORT

PRODUCT PACKAGE NUMBER RANGE MARKING NUMBER

(1)

MEDIA

AFE1144 SSOP-28 324 –40°C to +85°C AFE1144E AFE1144E Rails

" " " " " AFE1144E/1K Tape and Reel

NOTE: (1) Models with a slash (/) are available only in Tape and Reel in the quantities indicated (e.g., /1K indicates 1000 devices per reel). Ordering 1000 pieces
of “AFE1144E/1K” will get a single 1000-piece Tape and Reel.

PACKAGE/ORDERING INFORMATION

4

®

AFE1144

PIN # TYPE NAME DESCRIPTION

1 No Connection NC
2 No Connection NC
3 Power DV

DD

Digital Supply (+3.3 to +5V)
4 Ground DGND Digital Ground
5 Input txbaudCLK Transmit Baud Clock (584kHz for E1)
6 Input tx48xCLK Transmit Clock at 48x baud clock (28.032MHz for E1)
7 Input Data In Input Data Word
8 Input rxbaudCLK Receive baud clock (584kHz for E1)
9 Input rx48xCLK Receive clock at 48x baud clock (28.032MHz for E1)

10 Output Data Out Output Data Word
11 Power DV

DD

Digital Supply (+3.3 to +5V)

12 Ground DGND Digital Ground
13 Power AV

DD

Analog Supply (+5V)

14 Input rxHYB– Negative input from hybrid network
15 Input rxHYB+ Positive input from hybrid network
16 Input rxLINE– Negative line input
17 Input rxLINE+ Positive line input
18 Ground AGND Analog Ground
19 Output vrREFP Positive reference output
20 Output VCM Common-mode voltage (buffered)
21 Output vrREFN Negative reference output
22 Power AVDD Analog Supply (+5V)
23 Ground AGND Analog Ground
24 Output txLINE– Negative line output
25 Power AV

DD

Output buffer supply (+5V)

26 Output txLINE+ Positive line output
27 Ground AGND Output buffer ground
28 No Connection NC

PIN DESCRIPTIONS

BLOCK DIAGRAM

Pulse

Former

Filter

txbaudCLK

tx48xCLK

Data In

rxbaudCLK

rx48xCLK

Data Out

Output

Buffer

Voltage

Reference

∆Σ

Modulator

Transmit

Control

Receive

Control

Decimation

Filter

txLINE–

txLINE+

REF

P

V

CM

REF

N

rxLINE+
rxLINE–
rxHYB+
rxHYB–