Burr Brown UAF42AU-1, UAF42AU, UAF42AP-1, UAF42AP Datasheet

©
1990 Burr-Brown Corporation PDS-1070H Printed in U.S.A. January, 1998
FEATURES
VERSATILE—
LOW-PASS, HIGH-PASS BAND-PASS, BAND-REJECT
SIMPLE DESIGN PROCEDURE
ACCURATE FREQUENCY AND Q —
±0.5%
CAPACITORS
APPLICATIONS
TEST EQUIPMENT
COMMUNICATIONS EQUIPMENT
MEDICAL INSTRUMENTATION
DATA ACQUISITION SYSTEMS
MONOLITHIC REPLACEMENT FOR UAF41
UNIVERSAL ACTIVE FIL TER
DESCRIPTION
The UAF42 is a universal active filter which can be configured for a wide range of low-pass, high-pass, and band-pass filters. It uses a classical state-variable analog architecture with an inverting amplifier and two integrators. The integrators include on-chip 1000pF capacitors trimmed to 0.5%. This solves one of the most difficult problems of active filter design— obtaining tight tolerance, low-loss capacitors.
A DOS-compatible filter design program allows easy implementation of many filter types such as Butterworth, Bessel, and Chebyshev. A fourth, un­committed FET-input op amp (identical to the other
three) can be used to form additional stages, or for special filters such as band-reject and Inverse Chebyshev.
The classical topology of the UAF42 forms a time­continuous filter, free from the anomalies and switch­ing noise associated with switched-capacitor filter types.
The UAF42 is available in 14-pin plastic DIP and SOL-16 surface-mount packages, specified for the – 25°C to +85°C temperature range.
UAF42
International Airport Industrial Park • Mailing Address: PO Box 11400, Tucson, AZ 85734 • Street Address: 6730 S. Tucson Blvd., Tucson, AZ 85706 • Tel: (520) 746-1111 • Twx: 910-952-1111
Internet: http://www.burr-brown.com/ • FAXLine: (800) 548-6133 (US/Canada Only) • Cable: BBRCORP • Telex: 066-6491 • FAX: (520) 889-1510 • Immediate Product Info: (800) 548-6132
High-Pass
Out
R
R
R
1000pF
(1)
In
2
In
3
In
1
R
1000pF
(1)
Band-Pass
Out
Low-Pass
Out
GND
V+
V–
NOTE: (1) ±0.5%
R = 50k ±0.5%
UAF42
UAF42
UAF42
2
SPECIFICATIONS
ELECTRICAL
At TA = +25°C, VS = ±15V, unless otherwise noted.
UAF42AP, AU PARAMETER CONDITIONS MIN TYP MAX UNITS FILTER PERFORMANCE
Frequency Range, fn 0 to 100 kHz Frequency Accuracy f = 1kHz 1 % vs Temperature 0.01 %/°C Maximum Q 400 — Maximun (Q • Frequency) Product 500 kHz Q vs Temperature (f
O
• Q) < 10
4
0.01 %/°C
(f
O
• Q) < 10
5
0.025 %/°C
Q Repeatability (f
O
• Q) < 10
5
2% Offset Voltage, Low-Pass Output ±5mV Resistor Accuracy 0.5 1% %
OFFSET VOLTAGE
(1)
Input Offset Voltage ±0.5 ±5mV vs Temperature ±3 µV/°C vs Power Supply V
S
= ±6 to ±18V 80 96 dB
INPUT BIAS CURRENT
(1)
Input Bias Current VCM = 0V 10 50 pA Input Offset Current V
CM
= 0V 5 pA
NOISE
Input Voltage Noise
Noise Density: f = 10Hz 25 nV/Hz
f = 10kHz 10 nV/Hz
Voltage Noise: BW = 0.1 to 10Hz 2 µVp-p
Input Bias Current Noise
Noise Density: f = 10kHz 2 fA/Hz
INPUT VOLTAGE RANGE
(1)
Common-Mode Input Range ±11.5 V Common-Mode Rejection V
CM
= ±10V 80 96 dB
INPUT IMPEDANCE
(1)
Differential 1013 || 2 || pF Common-Mode 10
13
|| 6 || pF
OPEN-LOOP GAIN
(1)
Open-Loop Voltage Gain VO = ±10V, RL = 2k 90 126 dB
FREQUENCY RESPONSE
(1)
Slew Rate 10 V/µs Gain-Bandwidth Product G = +1 4 MHz Total Harmonic Distortion G = +1, f = 1kHz 0.0004 %
OUTPUT
(1)
Voltage Output RL = 2kΩ±11 ±11.5 V Short Circuit Current ±25 mA
POWER SUPPLY
Specified Operating Voltage ±15 V Operating Voltage Range ±6 ±18 V Current ±6 ±7mA
TEMPERATURE RANGE
Specification –25 +85 °C Operating –25 +85 °C Storage –40 +125 °C Thermal Resistance,
θ
JA
100 °C/W
The information provided herein is believed to be reliable; however, BURR-BROWN assumes no responsibility for inaccuracies or omissions. BURR-BROWN assumes no responsibility for the use of this information, and all use of such information shall be entirely at the user’s own risk. Prices and specifications are subject to change without notice. No patent rights or licenses to any of the circuits described herein are implied or granted to any third party. BURR-BROWN does not authorize or warrant any BURR-BROWN product for use in life support devices and/or systems.
Same as specification for UAF42AP. NOTES: (1) Specifications apply to uncommitted op amp, A
4
. The three op amps forming the filter are identical to A4 but are tested as a complete filter.
Loading...
+ 4 hidden pages