Burndy Wiley ACC-F49 Installation Instructions Manual

ACC-F490

Document Number 50091770 Rev B

© BURNDY LLC, 2018

Page 1 of 4

Wire Management Solution

ACME CABLE CLIP

INSTALLATION INSTRUCTIONS

BURNDY recommends that the sufficient details of the installation be

submitted to the AHJ for approval before any work is started.

Products are tested to UL 1565 & CSA C22.2 No. 18.5-13,

US/Canadian standards for safety Positioning Device.

Document Number 50091770 Rev B

© BURNDY LLC, 2018

Page 2 of 4

ACC-F490 COMPATIBILITY

Wire Management Solutions

Engineered for high-quality wire management solutions, Wiley Cable Clips simplify
wire management and lead to safer and more reliable wiring of the solar PV array.

The clips are made of corrosion resistant 304 stainless steel, which makes them
a durable, long lasting and reliable solution for all environments.

To install, push clip fully onto module frame. Insert wires by gently pushing into
cable compartment. Slight twisting of the wires will ease installation.
The design is easy to install, no tool is required for installation and removal.
Care should be taken to not over bend the clip when adding or removing wires.

Custom designs are available upon request.

Compatible on modules / purlins
with a flange thickness
range 1.0mm to 3.0mm

Designed to hold up to (4) USE-2 wires or up to (4) PV wires

Wire diameter range 5.0mm to 8.0mm (per each wire)

ACC-F490

Solar PV Module frame