Bunn-O-Matic TITAN Operation Manual
BEVERAGE DISPENSING
STEP 1 STEP 2 STEP 3 STEP 4
USE & CARE INSTRUCTIONS for TITAN™ SERVER
The Server Cover needs
to be removed to fill the
Server when brewing from
a Bunn-O-Matic® Titan™
Dual or Titan™ Single coffee
brewer.
DAILY CLEANING
STEP 1
When proper precautions
are followed, 1.5 up to 3.0
gallons of coffee may be
brewed directly into the
server and then transported
to a remote serving location.
The server must be placed on
a sturdy counter or shelf.
STEP 2 STEP 3 STEP 4
Place a cup or container under the faucet as indicated.
Open the faucet handle
until the desired quantity is
dispensed.
Run a complete brew cycle of
just hot water into the server
and let it set for a minute.
Empty the server completely
by opening the faucet.
NOTE: Bunn-O-Matic recommends the 3 step method for cleaning and sanitizing the server. The 3 step method
consists of hot soapy water using an approved detergent, a fresh water rinse, and an aqueous sanitizing solution
using an approved non-chlorine sanitizer. Do not submerge server.
41171.0000A 04/08 ©2008 Bunn-O-Matic Corporation
Remove the lid, fill server
with cleaning solution and
thoroughly clean the inside
of server.
Rinse server thoroughly using fresh water rinse.
Fully fill server with sanitizing solution for 5 minutes
then drain through fully open
faucet.
DAILY CLEANING (Continued)
USE & CARE INSTRUCTIONS for TITAN™ SERVER
Remove the faucet handle/
stem assembly by unscrewing the faucet nut just beneath the faucet handle.
STEP 9
STEP 6 STEP 7STEP 5
Remove the sight gauge cap
and tube from the shroud.
STEP 10 STEP 11
Use enclosed cleaning brush
to thoroughly clean the faucet spout.
STEP 8
Use enclosed cleaning brush
to thoroughly clean the fill
tube of the lid assembly.
Use enclosed cleaning brush
to thoroughly clean the sight
gauge tube.
Disassemble the faucet/
stem assembly. Thoroughly
wash all faucet parts and lid
in a mild detergent and water
solution. Rinse the parts in
hot water. Sanitize the parts
for five minutes, then air dry
completely.
Reassemble the faucet and
attach it, the lid and sight
gauge to the dispenser.
Wash the entire outside
surface of the server with a
clean damp cloth. Do NOT
clean this equipment with a
water jet device.
41171 042408
Loading...