Bunn-O-Matic OHW General Manual

ITE M#

PROJECT

Pourover Hot Water Dispenser

Features

Pourover Hot Water Dispenser

• Plugs into any 120 volt outlet, no plumbing needed.

• Steaming hot water constantly available for fast, hot refreshment preparation–
a quick cup at a time.

• No waiting. Draw hot water anytime–even immediately after refilling.

• Space-saving size to fit anywhere. Just 6.6” (16.8 cm) wide and 16.9”
(42.9 cm) high.

• High quality, easy-to-clean stainless steel exterior and tank for a long,
dependable life.

• Tank size: 80 oz. (2.37 litres)

• Includes drip tray

DATE

Dimensions: 16.9”H x 6.5”W x 10.8”D

(42.9cm H x 16.8cm W x 27.4cm D)

For current specification sheets and other information, go to www.bunn.com.

Related Products

Replacement Drip Tray Kit

Product No.: 02497.0001

Model OHW

Model Agency Listing

U

L

OHW

LISTED

7/10

E4

Dimensions & Specifications

3.58

2.26

8.54

7.08

1.00

5.06

5.71

6.57

16.66

3.92

.42

10.8

Model Product # Volts Amps Tank Heater Total ˚F Capacity Cu. Shipping Cord
Watts Watts Settings Ft. Weight Attached

3

ft

OHW 02550.0003 120 8.6 1000 1040 200 Pourover 1.9

*Power cord (NEMA 5-15P) 15 Amp-120V machine only.

Electrical: Model requires 2-wires plus ground service rated 120V, single phase, 60Hz.

13 lbs. Yes*

Bunn-O-Matic® Corporation - 1400 Stevenson Drive Springfield, Illinois 62703 • 800-637-8606 • 217-529-6601 • Fax [phone] • www.bunn.com

BUNN® practices continuous product research and improvement. We reserve the right to change specifications and product design without notice. Such
revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.

All dimensions shown in inches.

7/10 © Bunn-O-Matic Corporation