Bunn-O-Matic iMIX Operation Manual

CLEANING INSTRUCTIONS for iMIX POWDER MIX DISPENSERS

NOTICE - This guide is for quick reference only and is not intended to replace the information in the Operation Manual!

RECOMMENDED DAILY CLEANING

1. Empty the Drip Tray
and wash components
in a mild solution of dish
detergent using a bristle
brush. Rinse and dry each
item thoroughly before
reassembling.

2. Rinse out the Whipper Chambers by placing the
RINSE/RUN switch in the RINSE position and activat­ing the DISPENSE switch for 5 to 10 second bursts
for each hopper.

“S” Silver Series

shown above

Standard iMIX Series

shown above

DISASSEMBLY & CLEANING THE WHIPPER CHAMBERS (Once a week)

1. Open the Cabinet
Door.

2. Remove the steam
collector by pulling it for­ward and twisting in a
clockwise rotation.

3. Pull the Mixing Cham­ber out of the Whipper
Chamber.

3. Remove Hoppers and
refi ll with product.

4. Twist the Whipper
Chamber clockwise and
pull it off the Whipper
Chamber Receptacle.

5. Pull the Frother off
the Motor Shaft. Notice
the flat keyway on the
shaft and the matching
keyway inside the Frother.
It is important that these
two keyways are lined up
when reassembling.

6. Twist Whipper Cham­ber Receptacle clockwise
and pull it off the Motor
Shaft.

39230.0000A 06/06 ©2006 Bunn-O-Matic Corporation

7. Slip the O-ring off the
Whipper Chamber Re­ceptacle and remove the
shaft seal.

8. Wash components in
a mild solution of dish
detergent using a bristle
brush. Rinse and dry each
item thoroughly before
reassembling.

CLEANING INSTRUCTIONS for iMIX POWDER MIX DISPENSERS

THOROUGH CLEANING OF THE HOPPER (Once a week)

1. Open the Cabinet
Door.

6. Remove the Auger and
Auger Drive Shaft by pull­ing them out the front of
the hopper.

2. Remove the Hopper
Assembly from the Cabi­net. Remove the Cover
and empty the contents.

7. Wash all components
in a mild solution of dish
detergent using a bristle
brush when needed.
Rinse and dry each item
thoroughly before reas­sembling.

3. Pull the Ejector Elbow
off the Hopper Base.

8. Thoroughly wipe all surfaces with a clean wash cloth that has been dampened with
hot water. Wipe dry with a clean dry cloth before reassembling the dispenser.

4. Remove the Agitator
Disk and Mixing Blades
by spreading the hopper
walls slightly, and pulling
one, then the other Agita­tor disk shaft end from
the hopper wall pivots.

5. Firmly hold Auger with
one hand, and remove
Auger Drive Coupling by
turning it clockwise.

39230 060706