Bunn-O-Matic FMD-4 General Manual
ITE M#
Steam Collector
Mixing Chamber
Whipper Chamber
Receptacle
Whipper
Chamber
O-ring
Frother
Dispense
Tip
R
ELEA
SE BUTTO
N W
HEN CUP IS 2/3 FULL
PLAC
E
CUP HERE
Fresh Mix Dispenser
with 4 or 5 Hoppers
Features
Fresh Mix Dispensers with 4 or 5 Hoppers
• Capacity: FMD-4: One 8-pound hopper; three, 4-pound hoppers
FMD-5: Five, 4-pound hoppers
• Large, lighted front graphics for merchandising.
• 6.4 gallon (24.2 litres) hot water tank to meet peak serving times.
• Cup clearance at 7” (17.8 cm) to accommodate common cup sizes.
• Electrical and plumbing components easily accessible through front and top.
• Variable speed motors allow control of product consistency in mixing
chamber (.75 to 6.6 grams of powder per second).
• High speed, heavy-duty whipper for complete product mixing.
• Front of machine access to tank drain for easy service.
• Key lock on the door prevents tampering.
FMD-4
Dimensions: 29.3”H x 18.6”W x 21.2”D
(74.4 cm H x 47.2 cm W x 53.8 cm D)
PROJECT
DATE
FMD-5
Dimensions: 29.3”H x 18.6”W x 21.2”D
(74.4 cm H x 47.2 cm W x 53.8 cm D)
For current specification sheets and other information, go to www.bunn.com.
Related Products
Easy Clear
Product No. : 39000.0004
Easy Clear
Product No. : 39000.0001
®
EQHP-10
®
EQHP-10L
Features deluxe whipper chambers:
1. Robust whipper to ensure full flavor yield.
2. Specially designed self cleaning mixing
chamber.
3. Exhaust fan to siphon off moisture that
can cause powder buildup.
4. Hot water dispense for easy clean-out.
5. Quick disconnecting parts for thorough
sanitizing.
Model Agency Listing
FMD-5
FMD-4
Single hopper
model shown.
7/10
D4.1
Dimensions & Specifications
Model Product # Volts Amps Tank Heater Total Capacity Cubic Shipping Cord
Watts Watts Measure Weight Attached
FMD-4 34900.0002 120 15 1700 1800 4.2 gal/hr** 11 ft3 118 lbs. Yes*
FMD-5 34900.0000 120 15 1700 1800 4.2 gal/hr** 11 ft
*Power cord (NEMA 5-15P) 15 Amp-120V machine only. **Based on incoming water temperature of 50
3
123 lbs. Yes*
o
F/10˚C.
Electrical: 120V model requires 2-wires plus ground service rated 120V, single phase, 60 hz. 120/240V model requires
3-wires plus ground service rated 120/208 or 120/240V, single phase, 60Hz.
Plumbing: 20-100 psi (138-690 kPa) from a 3⁄8” or larger supply line. A shut-off valve should be installed in the line
before the unit. Install a regulator in line when pressure is greater than 90 psi to reduce it to 50 psi. Supplied
with 3⁄8” male flare fitting.
FRONT VIEW
19.30
19.30
FMD-4
FMD-5
BACK VIEW
SIDE VIEW
1.50
18.50
Bunn-O-Matic® Corporation - 1400 Stevenson Drive Springfield, Illinois 62703 • 800-637-8606 • 217-529-6601 • Fax 217-529-6644 • www.bunn.com
BUNN® practices continuous product research and improvement. We reserve the right to change specifications and product design without notice. Such
revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.
21.15
14.66
1.75
ADJ.
29.26
25.26
4.00
All dimensions shown in inches.
17.68
15.68
18.60
7/10 © 2010 Bunn-O-Matic Corporation
Loading...