Bunn-O-Matic EQHP-Tea General Manual

Easy Clear
®
HIGH PERFORMANCE WATER C ONDI TIONI NG S YSTE MS
Easy Clear® Water Softening System for Tea
Features
• Perfect for iced or hot tea brewers where hard water can affect tea clarity and taste.
• Increases tea stand time.
• Provides 4,350 grains of hardness reduction.
• Minimizes service maintenance and equipment downtime with reduced scale forming minerals.
• System includes a head assembly, integral mounting bracket and single cartridge filter.
• Quick Connect valve-in design simultaneously shuts off and vents water with 1/4 turn, allowing for siimple and trouble-free cartridge change-outs.
• Integrated carbon block media to reduce taste and odor.
• 3/8” FNPT horizontal inlet and outlet ports allow direct or easily adaptable connections to existing plumbing lines.
• System maximum operating pressure is 100 psi (862 kPa) and operating temperature 100˚F (38˚C).
ITE M#
PROJECT
DATE
Model EQHP-Tea
Water Quality System
For current specification sheets and other information, go to www.bunn.com.
Related Products
Warranty: BUNN warrants the Easy Clear® hardware (excluding cartridges) to be free from defects in materials and workmanship for 1 year from the date of installation. See service manual for complete warranty statement.
Replacement Cartridge
EQHP-TEACRTG Product No.: 39000.1007
Valve In-Head Assembly
EQHP-VHD Product No.: 39000.1000
Gauge
Product No.: 39000.0100
The Effects of Hardness and Stand Time on Iced Tea Clarity
Use of an Easy Clear water softening system can
dramatically improve the clarity of brewed iced tea.
Model Agency Listing
EQHP-Tea
7/10
F12
Dimensions & Specifications
Service
Model Product # Capacity
Softening Solutions
39000.0007 EQHP-TEA 4,350 grains 1 gpm 5 (nominal)
Note: Inlet and outlet plumbing connections are 3/8” FNPT.
Do I need a water softening system?
BUNN recommends that a water softening system be used when 10 grains per gallon (gpg) or more of hardening minerals are present in your water supply. If you are located in the shaded areas of the map below, then it is likely that you could use a water softening system.
Hardness of Water
(Hardness as CaCo3 in parts per million)
Flow Rate
Micron
Rating
Over 240 ppm 120-240 ppm (7-14 grains per gallon)
When do I need to replace my cartridge?
Cartridge Replacement
10 gpg 15 gpg 20 gpg 25 gpg
Chart
Incoming Water Hardness
(171 ppm) (256 ppm) (342 ppm) (427 ppm)
Number of 3 Gallon Brews 145 97 73 58
Bunn-O-Matic® Corporation - 1400 Stevenson Drive Springfield, Illinois 62703 • 800-637-8606 • 217-529-6601 • Fax 217-529-6644 • www.bunn.com
BUNN® practices continuous product research and improvement. We reserve the right to change specifications and product design without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.
All dimensions shown in inches.
7/10 © Bunn-O-Matic Corporation