Bunn-O-Matic CWTF BREWING Operation Manual
BREWING
CWTF BREWING & CLEANING INSTRUCTIONS
1. Insert a BUNN® lter into the
funnel.
5. Place an empty decanter under
the funnel.
CLEANING
2. Pour in fresh coffee.
6. Place the “ON/OFF” switch in the
“ON” upper position.
3. Shake funnel gently to level
grounds.
7. Momentarily press and release
the “START” switch.
4. Slide funnel into the funnel rails
of the brewer.
8. When brewing is complete,
discard the grounds and lter.
1. Clean and sanitize the funnel.
5. With the sprayhead removed,
insert a deliming spring into
the sprayhead tube until approximately two inches of the
sp rin g rem ain visi ble. Saw
back and forth ve or six times
to loosen any lime deposits.
36552.0000A 02/04 ©2004 Bunn-O-Matic Corporation
2. Use a clean damp cloth rinsed
in mild, non-abrasive detergent
to clean the sprayhead panel.
6. Flush the tube by running a
brew cycle using an empty
funnel and decanter. When the
cycle is completed, replace the
sprayhead.
3. Remove the sprayhead.
7. Use a clean damp cloth rinsed
in mild, non-abrasive detergent
to clean all outer surfaces.
4. Clean mineral deposits and
rinse. Make sure all holes are
open.
36552 020404
Loading...