Bunn-O-Matic CDBCFP BREWING Operation Manual
BREWING
CDBCFP BREWING & CLEANING INSTRUCTIONS
1. Remove & discard the clip. Open
fl ip lid.
5. Slide funnel into the funnel rails
of the brewer.
2. Insert a BUNN® fi lter into the
funnel.
6. Place an empty decanter under
the funnel.
3. Pour in fresh coffee.
7. Measure 64 ounces of cold
water in a container and slowly
pour the water into the pour-in
opening.
CLEANING
4. Shake funnel gently to level
grounds.
8. Press the “ON/OFF” button
to activate the lower warmer
(indicator lamp on).
NOTE: Do not press the BREW button. It is not necessary when using
the pour-over feature.
9. When brewing is complete,
discard the grounds and fi lter.
4.
3. Remove the sprayhead.
39644.0000A 12/06 ©2006 Bunn-O-Matic Corporation
Use the pointed end of sprayhead cleaning tool to remove
any mineral deposits from
the sprayhead openings. The
sprayhead openings must
always remain open.
1.
Clean and sanitize the funnel.
NOTE: Do NOT clean this
equipment with a water jet
device.
NOTE: Any buildup on the sprayhead and fi tting may restrict water
flow, and impact your coffee
brewing. For consistently great
coffee, clean sprayheads and
fittings weekly with sprayhead
cleaning tool (#38227.0000).
Upon visual inspection it may appear that light passes through all
openings in the sprayhead, but a
thin fi lm of residue can pass light
and still impede water fl ow.
2. Use a clean damp cloth rinsed
in mild, non-abrasive detergent
to clean the sprayhead panel.
5.
Use the blunt end of sprayhead cleaning tool to clean
the sprayhead outlet fi tting.
39644 121506
Loading...